David Hafler DH-120 amp in good all-around condition. It has a few dings and the Hafler logo on the front isnt perfect, but no major dents or scratches. The book says it delivers 60 watts per channel, but a couple of technical sites Ive visited tested it consistently at 72 wpc. I use it for quite a while and it was always great. Im selling it because I move to some higher-end gear.

Hafler DH 120 Power Amplifier FOR PART OR REPAIR ONLY - One Channel Out Tested and one channel came through sounding great and the other did not sound well. Some light static filter noise. Then it fizzled (the sound that is) and then the channel just went silent. I opened it up to check the inside, did not smell any issue and did not see any issue inside. Checked the fuses and all are good. See picture. This item is being sold in AS-IS condition FOR PARTS OR REPAIR ONLY! Also note the power cord was cut and put together again at some point.

This amplifier is in excellent cosmetic, considering its age. It works perfectly. It has been serviced and upgraded with better transistors. I certainly believe it sounds better than the original. DH-120 is the little-know secret of the Hafler line of amplifiers - it has the lowest distortion and the best sound as long as you do not need 100Wpc. Comparing to other Hafler amplifiers, it especially excels at higher frequencies. Note: the bridged mono circuit has been removed - it can be easily put back.

The Hafler DH-120 is a very high quality 60 watts-per-channel MOSFET class AB stereo power amplifier. MOSFETs are solid-state devices that work on principals more similar to vacuum tubes than bipolar transistors — and it sounds great! This 30-year-old sample easily put out 77 WPC continuous and 118 W burst power into 8?.ts a traditional class AB linear power amplifier in a sheet metal steel case. It has four power MOSFETs (2 per channel) in TO-3 packages mounted to two big, anodized aluminum heat sinks on opposite sides of the case. This also comes with 19 Standard rack mount plate.SpecificationsPower output: 60 watts per channel into 8? (stereo)Frequency response: 10Hz to 40kHzTotal harmonic distortion: 0.006%Damping factor: 50Input sensitivity: 1.1VSignal to noise ratio: 100dBSemiconductors: 22 x transistors, 4 x MOSfet, 23 x diodes, 8 x Zener diodes, 1 x diode bridgeDimensions: 3.75 x 15.75 x 9 inchesWeight: 18lbsYear: 1985

Hafler DH 120 Power Amplifier (device only) Used, in good overall condition. Has some minor marks/scratches but is in good shape otherwise. Comes with only what is pictured.Comes with only what is pictured, unless otherwise stated Please ask questions BEFORE you bid I Do Not Offer Buy it Now Prices On Auctions If you have any problems with the item please message me and we will work our hardest to resolve the issue Our eBay department is open 10am-6pm Monday to Friday (EASTERN). This is when items get shipped and questions get answered. We are not available to answer questions or ship on weekends or holidays. Payment Information Please check your local tax laws to determine if there is an online sales tax for out of state purchases Payment can be made either through eBay, or as cash upon local pickup Unpaid item cases will be opened 4 days after auction ends Shipping Information Item location: Glassboro, New Jersey My processing and handling time is 1 business days, however I try to ship within 24 hours of the payment being received. We only ship to the address used when purchasing the item. Return Policy Return shipping - Seller pays return shipping. However, if an item is being returned due to buyer remorse, the original shipping charge will not be refunded. Items that are used or damaged by the buyer are subject to a deduction in refund in accordance to eBay policy, per their guidelines: https://www.ebay.com/help/selling/managing-returns-refunds/handle-return-request-seller?id=4115#refund_guidelines

The Hafler DH-120 is a very high quality 60 watts-per-channel MOSFET class AB stereo power amplifier. MOSFETs are solid-state devices that work on principals more similar to vacuum tubes than bipolar transistors — and it sounds great! This 30-year-old sample easily put out 77 WPC continuous and 118 W burst power into 8?.ts a traditional class AB linear power amplifier in a sheet metal steel case. It has four power MOSFETs (2 per channel) in TO-3 packages mounted to two big, anodized aluminum heat sinks on opposite sides of the case. This also comes with 19 Standard rack mount plate.SpecificationsPower output: 60 watts per channel into 8? (stereo)Frequency response: 10Hz to 40kHzTotal harmonic distortion: 0.006%Damping factor: 50Input sensitivity: 1.1VSignal to noise ratio: 100dBSemiconductors: 22 x transistors, 4 x MOSfet, 23 x diodes, 8 x Zener diodes, 1 x diode bridgeDimensions: 3.75 x 15.75 x 9 inchesWeight: 18lbsYear: 1985

Hafler DH-120 60 Watt Stereo Power Amplifier - Works Great - Ships by UPS Ground

The Hafler DH-120 is a very high quality 60 watts-per-channel MOSFET class AB stereo power amplifier. MOSFETs are solid-state devices that work on principals more similar to vacuum tubes than bipolar transistors — and it sounds great! This 30-year-old sample easily put out 77 WPC continuous and 118 W burst power into 8?.ts a traditional class AB linear power amplifier in a sheet metal steel case. It has four power MOSFETs (2 per channel) in TO-3 packages mounted to two big, anodized aluminum heat sinks on opposite sides of the case. This also comes with 19 Standard rack mount plate.SpecificationsPower output: 60 watts per channel into 8? (stereo)Frequency response: 10Hz to 40kHzTotal harmonic distortion: 0.006%Damping factor: 50Input sensitivity: 1.1VSignal to noise ratio: 100dBSemiconductors: 22 x transistors, 4 x MOSfet, 23 x diodes, 8 x Zener diodes, 1 x diode bridgeDimensions: 3.75 x 15.75 x 9 inchesWeight: 18lbsYear: 1985

The Hafler DH-120 is a very high quality 60 watts-per-channel MOSFET class AB stereo power amplifier. MOSFETs are solid-state devices that work on principals more similar to vacuum tubes than bipolar transistors — and it sounds great! This 30-year-old sample easily put out 77 WPC continuous and 118 W burst power into 8?.ts a traditional class AB linear power amplifier in a sheet metal steel case. It has four power MOSFETs (2 per channel) in TO-3 packages mounted to two big, anodized aluminum heat sinks on opposite sides of the case. This also comes with 19 Standard rack mount plate.SpecificationsPower output: 60 watts per channel into 8? (stereo)Frequency response: 10Hz to 40kHzTotal harmonic distortion: 0.006%Damping factor: 50Input sensitivity: 1.1VSignal to noise ratio: 100dBSemiconductors: 22 x transistors, 4 x MOSfet, 23 x diodes, 8 x Zener diodes, 1 x diode bridgeDimensions: 3.75 x 15.75 x 9 inchesWeight: 18lbsYear: 1985

Unit in good condition with a few scratches on front and top, 60 watt into 8 ohms X 2 channels, 10 hz - 40 khz, 120 Vac.

I purchased this a while back and cleaned it up and repainted the face because it was scratched up. It works perfectly.

The Hafler DH-120 is a very high quality 60 watts-per-channel MOSFET class AB stereo power amplifier. MOSFETs are solid-state devices that work on principals more similar to vacuum tubes than bipolar transistors — and it sounds great! This 30-year-old sample easily put out 77 WPC continuous and 118 W burst power into 8?.ts a traditional class AB linear power amplifier in a sheet metal steel case. It has four power MOSFETs (2 per channel) in TO-3 packages mounted to two big, anodized aluminum heat sinks on opposite sides of the case. This also comes with 19 Standard rack mount plate.SpecificationsPower output: 60 watts per channel into 8? (stereo)Frequency response: 10Hz to 40kHzTotal harmonic distortion: 0.006%Damping factor: 50Input sensitivity: 1.1VSignal to noise ratio: 100dBSemiconductors: 22 x transistors, 4 x MOSfet, 23 x diodes, 8 x Zener diodes, 1 x diode bridgeDimensions: 3.75 x 15.75 x 9 inchesWeight: 18lbsYear: 1985

The Hafler DH-120 is a very high quality 60 watts-per-channel MOSFET class AB stereo power amplifier. MOSFETs are solid-state devices that work on principals more similar to vacuum tubes than bipolar transistors — and it sounds great! This 30-year-old sample easily put out 77 WPC continuous and 118 W burst power into 8?.ts a traditional class AB linear power amplifier in a sheet metal steel case. It has four power MOSFETs (2 per channel) in TO-3 packages mounted to two big, anodized aluminum heat sinks on opposite sides of the case. This also comes with 19 Standard rack mount plate.SpecificationsPower output: 60 watts per channel into 8? (stereo)Frequency response: 10Hz to 40kHzTotal harmonic distortion: 0.006%Damping factor: 50Input sensitivity: 1.1VSignal to noise ratio: 100dBSemiconductors: 22 x transistors, 4 x MOSfet, 23 x diodes, 8 x Zener diodes, 1 x diode bridgeDimensions: 3.75 x 15.75 x 9 inchesWeight: 18lbsYear: 1985

I purchased this a while back and cleaned it up and repainted the face because it was scratched up. It works perfectly.

The Hafler DH-120 is a very high quality 60 watts-per-channel MOSFET class AB stereo power amplifier. MOSFETs are solid-state devices that work on principals more similar to vacuum tubes than bipolar transistors — and it sounds great! This 30-year-old sample easily put out 77 WPC continuous and 118 W burst power into 8?.ts a traditional class AB linear power amplifier in a sheet metal steel case. It has four power MOSFETs (2 per channel) in TO-3 packages mounted to two big, anodized aluminum heat sinks on opposite sides of the case. This also comes with 19 Standard rack mount plate.SpecificationsPower output: 60 watts per channel into 8? (stereo)Frequency response: 10Hz to 40kHzTotal harmonic distortion: 0.006%Damping factor: 50Input sensitivity: 1.1VSignal to noise ratio: 100dBSemiconductors: 22 x transistors, 4 x MOSfet, 23 x diodes, 8 x Zener diodes, 1 x diode bridgeDimensions: 3.75 x 15.75 x 9 inchesWeight: 18lbsYear: 1985

I purchased this a while back and cleaned it up and repainted the face because it was scratched up. It works perfectly.

Unit in good condition with a few scratches on front and top, 60 watt into 8 ohms X 2 channels, 10 hz - 40 khz, 120 Vac.

The Hafler DH-120 is a very high quality 60 watts-per-channel MOSFET class AB stereo power amplifier. MOSFETs are solid-state devices that work on principals more similar to vacuum tubes than bipolar transistors — and it sounds great! This 30-year-old sample easily put out 77 WPC continuous and 118 W burst power into 8?.ts a traditional class AB linear power amplifier in a sheet metal steel case. It has four power MOSFETs (2 per channel) in TO-3 packages mounted to two big, anodized aluminum heat sinks on opposite sides of the case. This also comes with 19 Standard rack mount plate.SpecificationsPower output: 60 watts per channel into 8? (stereo)Frequency response: 10Hz to 40kHzTotal harmonic distortion: 0.006%Damping factor: 50Input sensitivity: 1.1VSignal to noise ratio: 100dBSemiconductors: 22 x transistors, 4 x MOSfet, 23 x diodes, 8 x Zener diodes, 1 x diode bridgeDimensions: 3.75 x 15.75 x 9 inchesWeight: 18lbsYear: 1985

I purchased this a while back and cleaned it up and repainted the face because it was scratched up. It works perfectly.

Unit in good condition with a few scratches on front and top, 60 watt into 8 ohms X 2 channels, 10 hz - 40 khz, 120 Vac.

The Hafler DH-120 is a very high quality 60 watts-per-channel MOSFET class AB stereo power amplifier. MOSFETs are solid-state devices that work on principals more similar to vacuum tubes than bipolar transistors — and it sounds great! This 30-year-old sample easily put out 77 WPC continuous and 118 W burst power into 8?.ts a traditional class AB linear power amplifier in a sheet metal steel case. It has four power MOSFETs (2 per channel) in TO-3 packages mounted to two big, anodized aluminum heat sinks on opposite sides of the case. This also comes with 19 Standard rack mount plate.SpecificationsPower output: 60 watts per channel into 8? (stereo)Frequency response: 10Hz to 40kHzTotal harmonic distortion: 0.006%Damping factor: 50Input sensitivity: 1.1VSignal to noise ratio: 100dBSemiconductors: 22 x transistors, 4 x MOSfet, 23 x diodes, 8 x Zener diodes, 1 x diode bridgeDimensions: 3.75 x 15.75 x 9 inchesWeight: 18lbsYear: 1985

I purchased this a while back and cleaned it up and repainted the face because it was scratched up. It works perfectly.

Unit in good condition with a few scratches on front and top, 60 watt into 8 ohms X 2 channels, 10 hz - 40 khz, 120 Vac.