Emotiva UPA-500 in great condition. Everything works perfectly. It was used to bi-amp a set of Linkwitz LX Mini speakers and sounded wonderfully. The speakers were sold so I have no use for this great amp. I included a stock photo of the inside of the unit. It includes the power cord, the Emotiva shipping box and the protective sleeve as shown. Again, this is a great amplifier, in very good cosmetic and operational condition with all channels working as they should. It was never abused and comes from a child free and smoke free environment. Mature owned. Please look at my feedback and bid with confidence. The amp will be shipped the same day payment is received. Rated at: 80 watts x 5 continuous @ 8 ohms (0.01% THD)120 watts x 5 continuous @ 4 ohms (0.01% THD) Sorry, no international shipping.

Circuit TopologyThe XPA-5 Gen3 is a fully modular audio power amplifier with a high-efficiency switch mode power supply (SMPS), independent, fully discrete, dual differential, high current, short signal path Class A/B amplifier modules, Optimized Class H™ power supply topology, and microprocessor-controlled fault protection.The XPA-5 is powered by a high efficiency, audiophile grade, Switch Mode Power Supply (SMPS).Audio SpecificationsThe XPA-5 Gen3 features five of our High-Powered Single Channel Modules.Audio Specifications (Five High-Powered Single Channel Modules):Power Output: 300 watts RMS/channel; 20 Hz – 20 kHz; THD<0.1%; 8 Ohms; one channel driven. 550 watts RMS/channel; 20 Hz – 20 kHz; THD<0.2%; 4 Ohms; one channel driven. 300 watts RMS/channel; THD<0.1%; 8 Ohms; two channels driven. 490 watts RMS/channel; THD<0.1%; 4 Ohms; two channels driven. 250 watts RMS/channel; THD<0.1%; 8 Ohms; ALL FIVE channels driven.Power Bandwidth (at rated power; 4 Ohm - 8 Ohm load): 20 Hz to 20 kHz (+ / – 0.1 dB).Broad Band Frequency Response: 5 Hz to 80 kHz +0/-2 dB.THD + noise: < 0.005%; at 100 watts RMS; 1 kHz; 8 Ohms.Signal to Noise Ratio (8 Ohm load): > 117 dB; ref FTC rated power; unbalanced input (A-weighted). > 91 dB; ref 1 watt; unbalanced input (A-weighted).Minimum Recommended Load Impedance (per channel): 4 Ohms (which equals one 4 Ohm load or two paralleled 8 Ohm loads).Damping Factor (8 Ohm load): > 500.Input Sensitivity (for rated power; 8 Ohm load): 1.5 V.Gain: 29 dB.Maximum Power Consumption: 2,000 watts. Note: The values shown refer to the amount of power the amplifier would consume while playing test tones continuously, on all channels, at full power, into a load bank. Therefore they are not at all characteristic of what you would expect when playing music or the sound track from a movie. Normal audio signals are dynamic, so the amount of power they require from second to second varies widely, and the average is far lower than this. With normal content, even playing very loudly, one of our amplifiers will consume far less power than indicated in the chart, so these values should not be considered to be a circuit requirement for normal operation.Input Impedance: 33 kOhms (balanced). 23.5 kOhms (unbalanced).Input And Output ConnectionsInput Connections (High-Powered Single Channel Modules): Unbalanced (RCA); balanced (XLR); one each per channel, independently selectable.Input Connections (Stereo Modules): 2 Unbalanced (RCA); 2 balanced (XLR); two per channel, independently selectable.Speaker Output Connections: Audiophile grade, gold plated, 5-way binding posts.Trigger: Trigger Input: 5 – 12 V (AC or DC); <10 mA input current required. Trigger Output: 12 VDC; can drive any load up to 120 mA.Power RequirementsBetween 100 VAC and 250 VAC @ 50 / 60 Hz (automatically detected).Front panel Controls and IndicatorsStandby: push button (halo ring changes color to indicate Standby or On).Status LEDs: one per channel; blue. Status LEDs change to red to indicate a fault condition.Rear Panel ControlsAC Power switch: rocker switch (switches AC main power).Status LEDs switch: disables front panel Status LEDs and dims Standby button halo.Input selector switches (one per channel): metal toggle switches; select between balanced and unbalanced inputs.Circuit Breaker: press button to reset circuit breaker.ProtectionThe XPA Gen3 is protected against excessive operating temperature, shorted speaker connections, ground faults, and other common fault conditions.MechanicalDimensions: 17” wide x 8” high x 19” deep (unboxed; including feet). 17” wide x 7” high x 19” deep (unboxed; without feet). 24-1/2” wide x 12” high x 24-3/4” deep (boxed).Weight: 46 lbs (unboxed). 51 lbs (boxed).

Purchased as refurbished unit directly from Emotiva. 1 owner since. Selling because of an upgrade. Plenty of power for almost all setups. Lightly used as a HT setup in a small apartment living room so never really pushed.Class A/B design with short signal path; Triple Darlington with Toshiba output stages; DualDifferential input; Balanced (XLR) and Un-balanced (RCA);Specifications:5 – independent mono blocks @ 200 wpc into 8 ohms; 350 wpc into 4 ohmsClass A/B design with short signal pathTriple Darlington with Toshiba output stagesDual Differential inputBalanced (XLR) and Un-balanced (RCA)Audiophile quality 5 way binding postTHD+N at rated power output: 0.007%S/N ratio: >100db10 to 120Khz (-3db) and 20 to 20 (with less than .15db deviation)32db gain structure1600VA toroidal transformer60,000uF secondary capacitance70 pounds17” W x 7.75” H x 19” DNo Box. Local pick up in 91677 preferred

This powerful Emotiva XPA-5 Gen 2 amplifier is a must-have for any audio enthusiast. With 5 channels and 300 watts at 4 ohms per channel, this amplifier delivers exceptional sound quality. It is compatible with a variety of audio systems and is guaranteed to enhance your listening experience. This amplifier is in good working condition, and has been thoroughly tested to ensure optimal performance. Upgrade your audio setup today with the Emotiva XPA-5 Gen 2 amplifier. XPA 5 Gen 2 specs: Number of channels:5 Topology:fully discrete, highly optimized dual differential, high current, short signal path Class A/B with premium components throughout Power output (all channels driven): 300 watts RMS @ 4 ohm (0.1% THD) 200 watts RMS @ 8 ohm (0.05% THD) Rated power bandwidth:20 Hz to 20 kHz +/- .075 dB Broadband Frequency response:5 Hz to 100 kHz, +0 -2dB Amplifier gain:29 dB Signal to Noise Ratio: 1 watt: > 95 dB Full power: > 119 dB Input impedance: unbalanced: 23.5 kohms balanced: 33 kohms Power supply:1,200VA toroidal transformer with 60,000uF storage capacitance Dimensions: unboxed: 17 wide x 7 3/4 high x 19 deep boxed: 23 1/2 wide x 12 high x 24 3/4 deep Weight:70.4 lbs Shows min wear if any. No factory. Includes power cord and manual. This thing is heavy! 70lbs Local pick up in Central Arkansas. Bring equipment needed to demo if you need a demo before purchase. Thanks Smoke free home.

I switched to a single 11 channel amp instead of the individual 5 channel amps and a 3 channel for my 11 channel theater. So now I am selling the XPA-5s. Awesome amplifiers. This listing is for one Emotiva XPA-5 (Gen 1) amplifier. It has the silver bars on the front but I do have one or two sets of the black bars, let me know if you want them, I will throw them in for free if I can find them. This will ship in the original box.

Unit is in great working condition. Small wear and tear scratches on top lid. Comes with power cable and factory boxing. Elevate your home theater experience with the Emotiva BasX A-500 Five-Channel Power Amplifier. This sleek and powerful amplifier delivers 110W RMS per channel, immersing you in clear and high-quality audio. With 5 unbalanced audio inputs and 5 audiophile-grade binding posts, you can easily connect all of your favorite audio devices. The BasX A-500 features an A/B amplifier class, ensuring that you get the best of both worlds in terms of power and efficiency. This black amplifier has been tested and proven excellent, making it the perfect addition to any home theater system. Upgrade your audio game with the Emotiva BasX A-500.

For sale is a very rare Emotiva UPA-5 Amplifier. 1200 Watts. In great shape. Was working perfectly when tested 6 months ago. Disconnected it for qa new system. Weights about 45 lbs. Measures 17 wide x 18 inches deep x 8 inches tall. Satisfaction guaranteed If for any reason you are unhappy with your purchase please contact me prior to leaving neutral or negative feedback as per ebay guidelines. I will do my best to rectify the situation. I will ship everything within 24 hours of payment

Up for auction here is one lightly used Emotiva BasX A-500 5 channel home theater power amplifier. All channels are fully tested, all are working properly. I will guarantee this to be working properly for 30 days from the day the buyer receives it,if it is not fully functional Ill refund your money upon return in undamaged condition in the box and packing I send it in, because it is professionally packed for safe shipment. Shipping is FREE within the USA.

Emotiva XPA-5 Gen 1- 5 Channel Amp - only 4 Channels Working. Condition is Used. Shipped with USPS Ground Advantage.