Fidelity Research FRT-5 Step up Transformer for MC Moving Coil Phono Cartridge Our price is 100% negotiable!Please make an offer and we will give you the best price! Payment PayPal ONLY. Please pay within 5 days after auction is finished. Shipping We ONLY ship to buyers Paypal registered address. Please Note International Buyers Import duties, taxes and charges are not included in the item price or shipping charges. These charges are the buyer responsibility. Please check with your country customs office to determine what these additional costs will be prior to bidding/buying. These charges are normally collected by the delivering freight (shipping) company or when you pick the item up - do not confuse them for additional shipping charges. I do not mark merchandise values below value or mark items as gifts- US and International government regulations prohibit such behavior.

Up for sale is my Audio Research Ref 2SE Phono Preamplifier in excellent condition. Only 595 Hours on Tubes! The Sound is magnificent. Will ship double boxed inside the pictured Audio Research Box. Included are original Power Cord and Remote. I invite you to check out my eBay feedback and bid with confidence! Original MSRP: $12,000.00 Specs: Frequency Response: ± .2dB of RIAA, 10Hz to 60kHz; 3dB points below 0.3Hz and above 300kHz. Distortion: Less than .002% at 1.0V RMS 1kHz output. Gain: Selectable 51dB (Low), 74dB (High) at 1kHz BAL; 45dB (Low), 68dB (High) at 1kHz SE. (MC & MM compatible). Buttons: Front (6) Power, Input, Gain, Load, RIAA, Mute. Remote adds ‘Hours’ and ‘Display’. Input Impedance: 47K ohms and 100pF SE. Selectable loads: 1000, 500, 200, 100, 50 ohms and Custom. Phono Equalization: (Selectable) RIAA, Columbia, Decca. Polarity: Non-Inverting. Output Impedance: 200 ohms SE, 400 ohms balanced. Recommended load 50K-100K ohms and 100pF. (10K ohms minimum and 2000pF maximum.) Maximum Input: 250mV RMS at 1kHz (680 mV RMS at 10kHz). Rated Outputs: 0.5V RMS 10Hz to 20kHz, 100K ohm load (output capability is 80V RMS BAL output at 1/2% THD at1kHz, 40V SE.) Power Supplies: Electronically-regulated low and high voltage supplies. Line regulation better than .01%. Noise: 0.22uV equivalent input noise, IHF weighted, shorted(Low Gain) input (73 dB below 1mV 1kHz input). 0.055uV equivalent input noise (High Gain) (65dB below 0.1mV 1kHz input). Power Requirements: 100-135VAC 60Hz (200-270VAC50/60Hz) 140 watts maximum. 2W standby. Line fuse 5A SLO BLO (T2A SLO BLO 230V). Dimensions: 19 (48 cm) W x 7 (17.8 cm) H (standard rack panel) x 15.5 (39.4 cm) D. Handles extend 1.5 (3.8 cm) forward of front panel.

Unit is in good cosmetic condition with some wear to the edge. Does not power on. I tested the fuse and it was good so not sure what’s wrong with it. Sold as is for parts.