The vintage TEAC AS-200S pre-main amplifier stands out for its innovative design and superior audio performance. With a full-scale differential amplifier circuit and double power supply system, it eliminates capacitors from the output circuit, enhancing transient characteristics in the low-frequency range. Special attention to the I/O circuit allows simultaneous recording on two tape decks, adding versatility to the setup. The preamp section utilizes carefully selected FETs for low noise operation, ensuring stability regardless of impedance change or input size. Additionally, the phono amplifier features a new 3-stage direct connection circuit for improved voltage utilization factor, while the tone control employs a highly accurate 3-dB-step switching method to eliminate channel imbalance. With its advanced features and meticulous design, the TEAC AS-200S offers exceptional audio quality and flexibility for vintage audio enthusiasts. Amplifier is in good workng condition. The front looks pretty good with some usage marks visible. The woodemn sides and top look not that bad too. Only issue is that trough the years the cabinet has lost some is stability. It is definitly not falling apart but there is some wiggle room in the cabnet. Amplifier is fully tested and sounds great 200S series integrated amplifier which was upgraded from AS-200 Specifications:Type Pre-main amplifierCircuit system Differential-type quasi complimentary service SEPPPower Amplifier UnitRated output (0.5% distortion rate, ± 0.5 dB) 60W + 60W (4 ?)50W + 50W (8 ?)Distortion Factor (1 kHz) 0.5% or Less (Rated Output)0.1% or Less (at 30W Output)0.1% or Less (at 100 mW Output)Cross modulation distortion factor 0.5% or Less (4 ? at 40W output)Frequency characteristic 20 Hz to 80 kHz + 0 -1dBPower Band Width 20 Hz to 30 kHzResidual noise 0.5 mV or lessInput impedance 25k ? or moreSensitivity 0.7 V (at rated output)Preamplifier SectionOutput (at cartridge 2 mv) Pre out:1.25VRec out:150mVCenter ch : 1 v (at rated output)Input Sensitivity / Impedance Phono1 : 2mV/50k ?Phono2 : 2mV/80k ?Tuner, Aux1/2, Tape1/2 : 130mV/100k ?Record and Reconnector (Din)Frequency characteristic Tuner, Aux, Tape : 30 Hz to 30 kHz + 0 -2dB* Built-in filter of 30 Hz or less for speaker protection)RIAA deviation ± 0.5 dBDistortion Factor (at 1 v output) 0.1% or Less (1 kHz)0.1% or Less (30 Hz)0.1% or Less (20 kHz)Tone control Bass : ± 15 dB or more (50 Hz)Treble : ± 15 dB or more (10 kHz)Loudness + 5 dB or more (100 Hz)Low-cut filter 100 Hz, -12dB/oct.High-cut filter 9 kHz, -12dB/oct.Signal-to-noise ratio (IHF) Phono1/2 : 70 dB or moreHigh level : 90 dB or higherSemiconductor used NPN transistor : 25 pcsPNP Transistor : 15FET : 2Diode : 13 pcsPwer 100 VAC, 50Hz/60HzPower consumption 22W (No signal)180W (at rated output)External dimensions Width 419x Height 151x Depth 297 mmWeight Approx. 9.5 kgVoltage: 220VCables : Not included Working condition: Fully Working (See pictures for the cosmetic condition of this lot)Missing or damages: Medium Usage Marks -We ship worldwide.We offer combine shipping (EU 30KG max, NON EU 20KG max) for all our listings, ask us for details Please note: ??Whenever an item exceeds the weight noted above. Please ask for a shipping quote before making a purchase. The shipping costs are estimated in our shop because we do not know the shipping address. -Shipping in the EU up to 30 KG (max)-Shipping outside of the EU up to 20 KG (max) Picking up the item is also possible. It can either be picked up in Alkmaar or Soest on appointment Delivery by us is also possible in some cases. Please reach out to us for more information about deliveries

The vintage TEAC AS-200S pre-main amplifier stands out for its innovative design and superior audio performance. With a full-scale differential amplifier circuit and double power supply system, it eliminates capacitors from the output circuit, enhancing transient characteristics in the low-frequency range. Special attention to the I/O circuit allows simultaneous recording on two tape decks, adding versatility to the setup. The preamp section utilizes carefully selected FETs for low noise operation, ensuring stability regardless of impedance change or input size. Additionally, the phono amplifier features a new 3-stage direct connection circuit for improved voltage utilization factor, while the tone control employs a highly accurate 3-dB-step switching method to eliminate channel imbalance. With its advanced features and meticulous design, the TEAC AS-200S offers exceptional audio quality and flexibility for vintage audio enthusiasts. Amplifier is in good workng condition. The front looks pretty good with some usage marks visible. The woodemn sides and top look not that bad too. Only issue is that trough the years the cabinet has lost some is stability. It is definitly not falling apart but there is some wiggle room in the cabnet. Amplifier is fully tested and sounds great 200S series integrated amplifier which was upgraded from AS-200 Specifications:Type Pre-main amplifierCircuit system Differential-type quasi complimentary service SEPPPower Amplifier UnitRated output (0.5% distortion rate, ± 0.5 dB) 60W + 60W (4 ?)50W + 50W (8 ?)Distortion Factor (1 kHz) 0.5% or Less (Rated Output)0.1% or Less (at 30W Output)0.1% or Less (at 100 mW Output)Cross modulation distortion factor 0.5% or Less (4 ? at 40W output)Frequency characteristic 20 Hz to 80 kHz + 0 -1dBPower Band Width 20 Hz to 30 kHzResidual noise 0.5 mV or lessInput impedance 25k ? or moreSensitivity 0.7 V (at rated output)Preamplifier SectionOutput (at cartridge 2 mv) Pre out:1.25VRec out:150mVCenter ch : 1 v (at rated output)Input Sensitivity / Impedance Phono1 : 2mV/50k ?Phono2 : 2mV/80k ?Tuner, Aux1/2, Tape1/2 : 130mV/100k ?Record and Reconnector (Din)Frequency characteristic Tuner, Aux, Tape : 30 Hz to 30 kHz + 0 -2dB* Built-in filter of 30 Hz or less for speaker protection)RIAA deviation ± 0.5 dBDistortion Factor (at 1 v output) 0.1% or Less (1 kHz)0.1% or Less (30 Hz)0.1% or Less (20 kHz)Tone control Bass : ± 15 dB or more (50 Hz)Treble : ± 15 dB or more (10 kHz)Loudness + 5 dB or more (100 Hz)Low-cut filter 100 Hz, -12dB/oct.High-cut filter 9 kHz, -12dB/oct.Signal-to-noise ratio (IHF) Phono1/2 : 70 dB or moreHigh level : 90 dB or higherSemiconductor used NPN transistor : 25 pcsPNP Transistor : 15FET : 2Diode : 13 pcsPwer 100 VAC, 50Hz/60HzPower consumption 22W (No signal)180W (at rated output)External dimensions Width 419x Height 151x Depth 297 mmWeight Approx. 9.5 kgVoltage: 220VCables : Not included Working condition: Fully Working (See pictures for the cosmetic condition of this lot)Missing or damages: Medium Usage Marks -We ship worldwide.We offer combine shipping (EU 30KG max, NON EU 20KG max) for all our listings, ask us for details Please note: ??Whenever an item exceeds the weight noted above. Please ask for a shipping quote before making a purchase. The shipping costs are estimated in our shop because we do not know the shipping address. -Shipping in the EU up to 30 KG (max)-Shipping outside of the EU up to 20 KG (max) Picking up the item is also possible. It can either be picked up in Alkmaar or Soest on appointment Delivery by us is also possible in some cases. Please reach out to us for more information about deliveries

The vintage TEAC AS-200S pre-main amplifier stands out for its innovative design and superior audio performance. With a full-scale differential amplifier circuit and double power supply system, it eliminates capacitors from the output circuit, enhancing transient characteristics in the low-frequency range. Special attention to the I/O circuit allows simultaneous recording on two tape decks, adding versatility to the setup. The preamp section utilizes carefully selected FETs for low noise operation, ensuring stability regardless of impedance change or input size. Additionally, the phono amplifier features a new 3-stage direct connection circuit for improved voltage utilization factor, while the tone control employs a highly accurate 3-dB-step switching method to eliminate channel imbalance. With its advanced features and meticulous design, the TEAC AS-200S offers exceptional audio quality and flexibility for vintage audio enthusiasts. Amplifier is in good workng condition. The front looks pretty good with some usage marks visible. The woodemn sides and top look not that bad too. Only issue is that trough the years the cabinet has lost some is stability. It is definitly not falling apart but there is some wiggle room in the cabnet. Amplifier is fully tested and sounds great 200S series integrated amplifier which was upgraded from AS-200 Specifications:Type Pre-main amplifierCircuit system Differential-type quasi complimentary service SEPPPower Amplifier UnitRated output (0.5% distortion rate, ± 0.5 dB) 60W + 60W (4 ?)50W + 50W (8 ?)Distortion Factor (1 kHz) 0.5% or Less (Rated Output)0.1% or Less (at 30W Output)0.1% or Less (at 100 mW Output)Cross modulation distortion factor 0.5% or Less (4 ? at 40W output)Frequency characteristic 20 Hz to 80 kHz + 0 -1dBPower Band Width 20 Hz to 30 kHzResidual noise 0.5 mV or lessInput impedance 25k ? or moreSensitivity 0.7 V (at rated output)Preamplifier SectionOutput (at cartridge 2 mv) Pre out:1.25VRec out:150mVCenter ch : 1 v (at rated output)Input Sensitivity / Impedance Phono1 : 2mV/50k ?Phono2 : 2mV/80k ?Tuner, Aux1/2, Tape1/2 : 130mV/100k ?Record and Reconnector (Din)Frequency characteristic Tuner, Aux, Tape : 30 Hz to 30 kHz + 0 -2dB* Built-in filter of 30 Hz or less for speaker protection)RIAA deviation ± 0.5 dBDistortion Factor (at 1 v output) 0.1% or Less (1 kHz)0.1% or Less (30 Hz)0.1% or Less (20 kHz)Tone control Bass : ± 15 dB or more (50 Hz)Treble : ± 15 dB or more (10 kHz)Loudness + 5 dB or more (100 Hz)Low-cut filter 100 Hz, -12dB/oct.High-cut filter 9 kHz, -12dB/oct.Signal-to-noise ratio (IHF) Phono1/2 : 70 dB or moreHigh level : 90 dB or higherSemiconductor used NPN transistor : 25 pcsPNP Transistor : 15FET : 2Diode : 13 pcsPwer 100 VAC, 50Hz/60HzPower consumption 22W (No signal)180W (at rated output)External dimensions Width 419x Height 151x Depth 297 mmWeight Approx. 9.5 kgVoltage: 220VCables : Not included Working condition: Fully Working (See pictures for the cosmetic condition of this lot)Missing or damages: Medium Usage Marks -We ship worldwide.We offer combine shipping (EU 30KG max, NON EU 20KG max) for all our listings, ask us for details Please note: ??Whenever an item exceeds the weight noted above. Please ask for a shipping quote before making a purchase. The shipping costs are estimated in our shop because we do not know the shipping address. -Shipping in the EU up to 30 KG (max)-Shipping outside of the EU up to 20 KG (max) Picking up the item is also possible. It can either be picked up in Alkmaar or Soest on appointment Delivery by us is also possible in some cases. Please reach out to us for more information about deliveries