The surround receiver is used, but in very good condition. Everything works as it should. It comes double-packaged so it is well protected during transport. I do not offer a guarantee or returns.It comes in its original packaging, remote control, calibration microphone, etc. It is also available elsewhere, I will end this on ebay if it is sold elsewhere. Shipping to Germany with GLS 50,-Euro For other country please ask. Der Surround-Receiver ist gebraucht, aber in sehr gutem Zustand. Alles funktioniert wie es soll. Es wird in einer Doppelverpackung geliefert, sodass es beim Transport gut geschützt ist. Ich biete keine Garantien oder Rücksendungen an.Es wird in Originalverpackung, Fernbedienung, Kalibrierungsmikrofon usw. geliefert. Es steht auch woanders zum Verkauf, ich werde es hier bei eBay beenden, wenn es woanders verkauft wird. Versand nach Deutschland mit GLS 50,-Euro. Für andere Länder fragen Sie. Audio section Power amplifier Rated output: Front: 125 W + 125 W (8 ?/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.) 165 W + 165 W (6 ?/ohms, 1 kHz with 0.7 % T.H.D.) Center: 125 W (8 ?/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.) 165 W (6 ?/ohms, 1 kHz with 0.7 % T.H.D.) Surround: 125 W + 125 W (8 ?/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.) 165 W + 165 W (6 ?/ohms, 1 kHz with 0.7 % T.H.D.) Surround back / Height1 / Height2: 125 W + 125 W (8 ?/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.) 165 W + 165 W (6 ?/ohms, 1 kHz with 0.7 % T.H.D.) Output connectors: 4 – 16 ?/ohmsAp Analog Input sensitivity: 200 mV Frequency response: 10 Hz – 100 kHz — +1, –3 dB (Direct mode) S/N: 100 dB (IHF–A weighted, Direct mode) Distortion: 0.005 % (20 Hz – 20 kHz) (Direct mode) Rated output: 1.2 V Digital D/A output: Rated output — 2 V (at 0 dB playback) Total harmonic distortion — 0.008 % (1 kHz, at 0 dB) S/N ratio — 102 dB Dynamic range — 100 dB Digital input: Format — Digital audio interface Phono equalizer Input sensitivity: 2.5 mV RIAA deviation: ±1 dB (20 Hz to 20 kHz) S/N: 74 dB (IHF-A) Distortion factor: 0.03 % (1 kHz, 3 V)ix Video section Standard video connectors Input/output level and impedance: 1 Vp-p, 75 ?/ohms Frequency response: 5 Hz – 10 MHz — 0, –3 dB Color component video connector Input/output level and impedance: Y signal — 1 Vp-p, 75 ?/ohms PB / CB signal — 0.7 Vp-p, 75 ?/ohms PR / CR signal — 0.7 Vp-p, 75 ?/ohms Frequency response: 5 Hz – 60 MHz — 0, –3 dB Tuner section [FM] [AM] (Note: ?V at 75 ?/ohms, 0 dBf = 1 x 10 –15 W) Reception frequency range: 87.5 MHz – 108.0 MHz 522 kHz – 1611 kHz Effective sensitivity: 1.2 ?V (12.8 dBf) 18 ?V 50 dB sensitivity: MONO ? 2.8 ?V (20.2 dBf) S/N ratio: MONO ? 70 dB (IHF–A weighted, Direct mode) STEREO ? 67 dB (IHF–A weighted, Direct mode) Distortion: MONO ? 0.7 % (1 kHz) STEREO ? 1.0 % (1 kHz) Wireless LAN section Network type (wireless LAN standard): Conforming to IEEE 802.11a/b/g/n (Wi-Fi® compliant) z1 Security: WEP 64 bit, WEP 128 bit WPA/WPA2-PSK (AES) WPA/WPA2-PSK (TKIP) Used frequency range: 2.4 GHz, 5 GHz *1 The Wi-Fi® CERTIFIED Logo and the Wi-Fi CERTIFIED On-Product Logo are registered trademarks of the Wi-Fi Alliance. Bluetooth section Communications system: Bluetooth Specification Version 3.0 + EDR (Enhanced Data Rate) Transmission power: Bluetooth Specification Power Class 1 Maximum communication range: Approx. 30 m in line of sight z2 Used frequency range: 2.4 GHz Modulation scheme: FHSS (Frequency-Hopping Spread Spectrum) Supported profiles: A2DP (Advanced Audio Distribution Profile) 1.2 AVRCP (Audio Video Remote Control Profile) 1.5 Corresponding codec: SBC Transmission range (A2DP): 20 Hz – 20,000 Hz *2 The actual communication range varies depending on the influence of such factors as obstructions between devices, electromagnetic waves from microwave ovens, static electricity, cordless phones, reception sensitivity, antenna performance, operating system, application software etc. General Power supply: AC 230 V, 50/60 Hz Power consumption: 710 W Power consumption in standby mode: 0.2 W Power consumption in CEC standby mode: 0.5 W For purposes of improvement, specifications and design are subject to change without notice.

The surround receiver is used, but in very good condition. Everything works as it should. It comes double-packaged so it is well protected during transport. I do not offer a guarantee or returns.It comes in its original packaging, remote control, calibration microphone, etc. It is also available elsewhere, I will end this on ebay if it is sold elsewhere. Shipping to Germany with GLS 50,-Euro For other country please ask. Der Surround-Receiver ist gebraucht, aber in sehr gutem Zustand. Alles funktioniert wie es soll. Es wird in einer Doppelverpackung geliefert, sodass es beim Transport gut geschützt ist. Ich biete keine Garantien oder Rücksendungen an.Es wird in Originalverpackung, Fernbedienung, Kalibrierungsmikrofon usw. geliefert. Es steht auch woanders zum Verkauf, ich werde es hier bei eBay beenden, wenn es woanders verkauft wird. Versand nach Deutschland mit GLS 50,-Euro. Für andere Länder fragen Sie. Audio section Power amplifier Rated output: Front: 125 W + 125 W (8 ?/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.) 165 W + 165 W (6 ?/ohms, 1 kHz with 0.7 % T.H.D.) Center: 125 W (8 ?/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.) 165 W (6 ?/ohms, 1 kHz with 0.7 % T.H.D.) Surround: 125 W + 125 W (8 ?/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.) 165 W + 165 W (6 ?/ohms, 1 kHz with 0.7 % T.H.D.) Surround back / Height1 / Height2: 125 W + 125 W (8 ?/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.) 165 W + 165 W (6 ?/ohms, 1 kHz with 0.7 % T.H.D.) Output connectors: 4 – 16 ?/ohmsAp Analog Input sensitivity: 200 mV Frequency response: 10 Hz – 100 kHz — +1, –3 dB (Direct mode) S/N: 100 dB (IHF–A weighted, Direct mode) Distortion: 0.005 % (20 Hz – 20 kHz) (Direct mode) Rated output: 1.2 V Digital D/A output: Rated output — 2 V (at 0 dB playback) Total harmonic distortion — 0.008 % (1 kHz, at 0 dB) S/N ratio — 102 dB Dynamic range — 100 dB Digital input: Format — Digital audio interface Phono equalizer Input sensitivity: 2.5 mV RIAA deviation: ±1 dB (20 Hz to 20 kHz) S/N: 74 dB (IHF-A) Distortion factor: 0.03 % (1 kHz, 3 V)ix Video section Standard video connectors Input/output level and impedance: 1 Vp-p, 75 ?/ohms Frequency response: 5 Hz – 10 MHz — 0, –3 dB Color component video connector Input/output level and impedance: Y signal — 1 Vp-p, 75 ?/ohms PB / CB signal — 0.7 Vp-p, 75 ?/ohms PR / CR signal — 0.7 Vp-p, 75 ?/ohms Frequency response: 5 Hz – 60 MHz — 0, –3 dB Tuner section [FM] [AM] (Note: ?V at 75 ?/ohms, 0 dBf = 1 x 10 –15 W) Reception frequency range: 87.5 MHz – 108.0 MHz 522 kHz – 1611 kHz Effective sensitivity: 1.2 ?V (12.8 dBf) 18 ?V 50 dB sensitivity: MONO ? 2.8 ?V (20.2 dBf) S/N ratio: MONO ? 70 dB (IHF–A weighted, Direct mode) STEREO ? 67 dB (IHF–A weighted, Direct mode) Distortion: MONO ? 0.7 % (1 kHz) STEREO ? 1.0 % (1 kHz) Wireless LAN section Network type (wireless LAN standard): Conforming to IEEE 802.11a/b/g/n (Wi-Fi® compliant) z1 Security: WEP 64 bit, WEP 128 bit WPA/WPA2-PSK (AES) WPA/WPA2-PSK (TKIP) Used frequency range: 2.4 GHz, 5 GHz *1 The Wi-Fi® CERTIFIED Logo and the Wi-Fi CERTIFIED On-Product Logo are registered trademarks of the Wi-Fi Alliance. Bluetooth section Communications system: Bluetooth Specification Version 3.0 + EDR (Enhanced Data Rate) Transmission power: Bluetooth Specification Power Class 1 Maximum communication range: Approx. 30 m in line of sight z2 Used frequency range: 2.4 GHz Modulation scheme: FHSS (Frequency-Hopping Spread Spectrum) Supported profiles: A2DP (Advanced Audio Distribution Profile) 1.2 AVRCP (Audio Video Remote Control Profile) 1.5 Corresponding codec: SBC Transmission range (A2DP): 20 Hz – 20,000 Hz *2 The actual communication range varies depending on the influence of such factors as obstructions between devices, electromagnetic waves from microwave ovens, static electricity, cordless phones, reception sensitivity, antenna performance, operating system, application software etc. General Power supply: AC 230 V, 50/60 Hz Power consumption: 710 W Power consumption in standby mode: 0.2 W Power consumption in CEC standby mode: 0.5 W For purposes of improvement, specifications and design are subject to change without notice.