Antronix VoIP Residential Amplifier (VRA900) Amp Coaxial Splitter - Pre-Owned. Pictures are of the actual item. Please reference the photos to determine the condition for yourself. Any imperfections & blemishes have been depicted. Please thoroughly view the pictures to determine the condition. Pre-Owned, Good Condition.

Antronix VoIP Residential Amplifier (VRA900) Amp Coaxial Splitter - Pre-Owned. Pictures are of the actual item. Please reference the photos to determine the condition for yourself. Any imperfections & blemishes have been depicted. Please thoroughly view the pictures to determine the condition. Pre-Owned, Good Condition.

Antronix VoIP Residential Amplifier (VRA900) Amp Coaxial Splitter - Pre-Owned. Pictures are of the actual item. Please reference the photos to determine the condition for yourself. Any imperfections & blemishes have been depicted. Please thoroughly view the pictures to determine the condition. Pre-Owned, Good Condition.

Antronix VoIP Residential Amplifier (VRA900) Amp Coaxial Splitter - Pre-Owned. Pictures are of the actual item. Please reference the photos to determine the condition for yourself. Any imperfections & blemishes have been depicted. Please thoroughly view the pictures to determine the condition. Pre-Owned, Good Condition.

Antronix VoIP Residential Amplifier (VRA900) Amp Coaxial Splitter - Pre-Owned. Pictures are of the actual item. Please reference the photos to determine the condition for yourself. Any imperfections & blemishes have been depicted. Please thoroughly view the pictures to determine the condition. Pre-Owned, Good Condition.

Antronix VoIP Residential Amplifier (VRA900) Amp Coaxial Splitter - Pre-Owned. Pictures are of the actual item. Please reference the photos to determine the condition for yourself. Any imperfections & blemishes have been depicted. Please thoroughly view the pictures to determine the condition. Pre-Owned, Good Condition.

Antronix VoIP Residential Amplifier (VRA900) Amp Coaxial Splitter - Pre-Owned. Pictures are of the actual item. Please reference the photos to determine the condition for yourself. Any imperfections & blemishes have been depicted. Please thoroughly view the pictures to determine the condition. Pre-Owned, Good Condition.

Bought these from Watford valves a few months back but never used because it turned out a power tube was faulty on my amp, not the pre-amp. Selling as a set of 5.

Antronix VoIP Residential Amplifier (VRA900) Amp Coaxial Splitter - Pre-Owned. Pictures are of the actual item. Please reference the photos to determine the condition for yourself. Any imperfections & blemishes have been depicted. Please thoroughly view the pictures to determine the condition. Pre-Owned, Good Condition.

I bought this along with some other equipment for the home of an audiophile. I plugged it in and it all seems to work fine, but there is one button cover missing off of the front (see photos) and I noticed that the power cord was not the right one and that it had a couple of loose screws so I took the cover off. Even though it works just perfectly, I noticed that the original owner had changed out some of the internal wires with thickly insulated ones as can be seen in the photos. There is one screw missing that holds the cover on, but I did put on the appropriate power cord. There is a little bit of sticky tape on the top back cover. For shipping information, click on the shipping tab on the listing page and fill in your information.

Electro-Harmonix 12AY7 Mic Pre Electro-Harmonix 12AY7 Mic Pre in good working condition. Comes with Ninja Pedals Stickers | Fast Shipping! Comes with hard to find EHX power supply that these require From EHX: This high-voltage, pure class ‘A’ tube path has an 80kHz bandwidth, making it ideal for use with your favorite 96-192kHz A/D converter, high-end analog or digital console, or recording system. This dedicated microphone preamplifier has a single XLR input with an infinitely variable attenuator offering up to 50dB of gain Two premium Electro-Harmonix vacuum tubes, a 12AU7 and a 12AY7, operate at 200V, providing incredibly low distortion and high dynamic range. A discreet, matched, FET-based current balancing circuit allows for a low-cost, transformer-less design, offering more than 80dB of CMRR. The 12AY7 Mic Pre is small, portable and lightweight, allowing studios to place it near the mic and run it line-level to recorders and monitor mixers. Separate XLR and ¼” balanced outputs can be used to split the signal for recording and monitoring in live performance applications. A host of standard features allow the 12AY7 to interface with most microphones and line-level input. Engaging the 48-volt phantom supply produces a “pop”-free ramp up. the 48 volt phantom supply supplies 10mA. Some modern direct-coupled condenser mics require more than this… you will need to test for best results. nearly all older condenser mics and all dynamic mics will be easily employed. The 12AY7’s Low-Cut filter is useful for controlling proximity effect and reducing rumble from wind or vibration. Also included is a Phase Reverse switch, which allows alignment at 0 or 180 degrees. Placement of multiple mics on common sources can affect overall sound. Toggling this switch inverts the phase of 12AY7. POWER LED – This blue LED should glow brightly when the correct 12-volt /1 Amp AC power is applied, signaling that all operational voltages are satisfactory. INPUT GAIN/OVERLOAD LED – The input gain knob controls the pad before the first tube gain stage, providing a range of 50dB. This range will work for dynamic, condenser and ribbon microphone types in most applications. We have provided enough gain to allow the large orange overload indicator to glow regularly if desired. This overload characteristic is musical in nature, with soft, warm, natural tube clipping that is great for blues harmonica. The OVERLOAD LED will begin to light at 0dBm and light solid at +4dBm or about +6dBu and +10dBu respectively PHANTOM PWR/LED – Engages/disengages +48Volts on pin 2 and 3 of the input XLR. Turn on/Turn off transients, which could harm mics or monitor speakers, are eliminated by a slow ramp on/off power circuit. The Phantom LED should glow bright green when the phantom is active. Some condenser mics require more than the 10mA available for optimum use. LOW CUT – Engages a simple, single-pole high-pass filter at 80Hz. This can be used to change the character of the mic, modify proximity effect or reduce rumble. PHASE REV– This switch enables the user to invert their phase at the microphone input. Phase problems can occur when multiple similar mics are used in close proximity of the same sound source. Changing the phase typically can be heard as going between a thick or thin-sounding recording. This is dependant on the phase of the additional sound sources. This feature is also useful for accommodating XLR cables that have pin 2 and pin 3 swapped. ¼” OUTPUT LEVEL – This separate, buffered output with a dedicated level control is “balanced out,” which can provide +18dBu. Shorting the ring to the sleeve allows for use of single-ended unbalance cables in some equipment. Test for best results. Electro-Harmonix 12AY7 Mic Pre Electro-Harmonix 12AY7 Mic Pre in good working condition. Comes with Ninja Pedals Stickers | Fast Shipping! Comes with hard to find EHX power supply that these require From EHX: This high-voltage, pure class ‘A’ tube path has an 80kHz bandwidth, making it ideal for use with your favorite 96-192kHz A/D converter, high-end analog or digital console, or recording system. This dedicated microphone preamplifier has a single XLR input with an infinitely variable attenuator offering up to 50dB of gain Two premium Electro-Harmonix vacuum tubes, a 12AU7 and a 12AY7, operate at 200V, providing incredibly low distortion and high dynamic range. A discreet, matched, FET-based current balancing circuit allows for a low-cost, transformer-less design, offering more than 80dB of CMRR. The 12AY7 Mic Pre is small, portable and lightweight, allowing studios to place it near the mic and run it line-level to recorders and monitor mixers. Separate XLR and ¼” balanced outputs can be uséd to split the signal for recording and monitoring in live performance applications. A host of standard features allow the 12AY7 to interface with most microphones and line-level input. Engaging the 48-volt phantom supply produces a “pop”-free ramp up. the 48 volt phantom supply supplies 10mA. Some modern direct-coupled condenser mics require more than this… you will need to test for best results. nearly all older condenser mics and all dynamic mics will be easily employed. The 12AY7’s Low-Cut filter is useful for controlling proximity effect and reducing rumble from wind or vibration. Also included is a Phase Reverse switch, which allows alignment at 0 or 180 degrees. Placement of multiple mics on common sources can affect overall sound. Toggling this switch inverts the phase of 12AY7. POWER LED – This blue LED should glow brightly when the correct 12-volt /1 Amp AC power is applied, signaling that all operational voltages are satisfactory. INPUT GAIN/OVERLOAD LED – The input gain knob controls the pad before the first tube gain stage, providing a range of 50dB. This range will work for dynamic, condenser and ribbon microphone types in most applications. We have provided enough gain to allow the large orange overload indicator to glow regularly if desired. This overload characteristic is musical in nature, with soft, warm, natural tube clipping that is great for blues harmonica. The OVERLOAD LED will begin to light at 0dBm and light solid at +4dBm or about +6dBu and +10dBu respectively PHANTOM PWR/LED – Engages/disengages +48Volts on pin 2 and 3 of the input XLR. Turn on/Turn off transients, which could harm mics or monitor speakers, are eliminated by a slow ramp on/off power circuit. The Phantom LED should glow bright green when the phantom is active. Some condenser mics require more than the 10mA available for optimum use. LOW CUT – Engages a simple, single-pole high-pass filter at 80Hz. This can be uséd to change the character of the mic, modify proximity effect or reduce rumble. PHASE REV– This switch enables the user to invert their phase at the microphone input. Phase problems can occur when multiple similar mics are uséd in close proximity of the same sound source. Changing the phase typically can be heard as going between a thick or thin-sounding recording. This is dependant on the phase of the additional sound sources. This feature is also useful for accommodating XLR cables that have pin 2 and pin 3 swapped. ¼” OUTPUT LEVEL – This separate, buffered output with a dedicated level control is “balanced out,” which can provide +18dBu. Shorting the ring to the sleeve allows for use of single-ended unbalance cables in some equipment. Test for best results. × × × × × × × × Buy now and save! Shipping info Click the Shipping & Payments tab above the listing description for more info FREE Shipping Click the Shipping & Payments tab above the listing description for more info! Additional delivery notes PICK UP OPTION Sorry, our items are NOT available for pick-up. PAYMENT Immediate payment is required upon selecting Buy It Now or upon checking out through the cart. We accept payment via U.S. PayPal accounts and all Major Credit Cards, Debit Cards & Google Pay. We are legally required to collect sales tax in those states and localities where we maintain a physical presence (nexus). The applicable amount of sales tax charged to an order will be calculated based on the shipment destinations state and local sales tax laws. Thank you for shopping with us on eBay! Additional Information No additional information at this time Ask seller a question You might also like Zoom G2.1NU Multi-Effects Processor Carvin DB-3 Direct Box Animals Pedal Vintage Van Driving Is Very Fun Overdrive Boss PW-10 V-Wah w/Box Contact To contact our Customer Service Team, simply click the button here and our Customer Service team will be happy to assist. Ask seller a question © Ninja Pedals Shipping & Payments Shipping is FREE for this item Payment Accepted Payment Methods Immediate payment is required upon selecting Buy It Now or upon checking out through the cart. We accept payment via U.S. PayPal accounts and all Major Credit Cards, Debit Cards & Google Pay. We are legally required to collect sales tax in those states and localities where we maintain a physical presence (nexus). The applicable amount of sales tax charged to an order will be calculated based on the shipment destinations state and local sales tax laws. Thank you for shopping with us on eBay! Returns Returns are accepted Items must be returned within 30 days of the auction ending Buyer will pay for return shipping. eBay integration by

2-way Splitters Lot of 5 Different Brand Regal, Antronix, Radio Shack, Archer & Drop Shop. Pre-Owned Condition ( see Photos)

3-way Splitters Lot of 2 Different Brands, 1 Antronix And 1 unbranded Pre-Owned Condition ( see Photos)

I bought this along with some other equipment for the home of an audiophile. I plugged it in and it all seems to work fine, but there is one button cover missing off of the front (see photos) and I noticed that the power cord was not the right one and that it had a couple of loose screws so I took the cover off. Even though it works just perfectly, I noticed that the original owner had changed out some of the internal wires with thickly insulated ones as can be seen in the photos. There is one screw missing that holds the cover on, but I did put on the appropriate power cord. There is a little bit of sticky tape on the top back cover. For shipping information, click on the shipping tab on the listing page and fill in your information.

Antronix VoIP Residential Amplifier (VRA900) Amp Coaxial Splitter - Pre-Owned. Pictures are of the actual item. Please reference the photos to determine the condition for yourself. Any imperfections & blemishes have been depicted. Please thoroughly view the pictures to determine the condition. Pre-Owned, Good Condition.

For your consideration are two Electro Harmonix 12AX7 ECC83 These tubes were tested on a Hickok 539C where the minimum reading is 875gm and the reading for a new tube is 1375gm or better. The tubes tested at 1400gm/1300gm & 1300gm/1300gm

Item TitleU.K. Onix Oa21S Rare Pre-Main Lifier With Phono Payment Supports managed payments Please pay within 5 days after auction is finished. About Us We are located in Japan. Its our pleasure to make you happy by proposing our recommend item. If you have any questions or request about items please feel free to ask us. International Buyers - Please Note: -Import duties taxes and charges are not included in the item price or shipping charges. These charges are the buyers responsibility. -Please check with your countrys customs office to determine what these additional costs will be prior to bidding/buying. -These charges are normally collected by the delivering freight (shipping) company or when you pick the item up - do not confuse them for additional shipping charges. -We do not mark merchandise values below value or mark items as - gifts - The US and International government regulations prohibit such behavior. Thank you for your understanding.