Description
This CD player is the successor to the S10 and uses a new anti-vibration mechanism. In addition to adopting a center mechanism mount with high structural stability, it also uses a mechanism cover that cuts the impact on the circuitry that is the driving mechanism. In addition, the vibration-absorbing material Ecsaine is attached to the sintered alloy insulator, which converts vibration into heat and suppresses its transmission to the chassis, further suppressing the transmission of vibration.The 15mm thick front panel, double-layered bottom cover, and top cover thoroughly eliminate the deterioration of sound quality caused by vibration from both inside and outside. A hybrid structure loader is used for the tray.The tray is made of protein-blended paint that has high vibration-proofing properties to suppress unnecessary vibration.In addition, a lightweight, high-rigidity aluminum die-cast shaft receiver that is highly effective in suppressing vibration is used, and a plate is attached to the bottom of the tray to suppress the subtle deformation of the tray due to the rotation of the disc, ensuring stable rotation and absorbing vibration. Bearings are used in the main body receiver of the tray rail, achieving smooth tray drive.This not only ensures accurate tray storage, but also minimizes the impact of vibration on the sound by securely holding the tray. Equipped with the ALPHA processor, a unique analog waveform reproduction technology.It interpolates the signals lost when recorded as digital data on CDs, etc., and reproduces a smooth waveform close to analog by getting as close as possible to the sound that should have existed before recording. In addition, the quantization distortion that was the fate of digital has been greatly reduced, resulting in a reproduction performance closer to the original sound. The D/A conversion section uses DENONs unique Lambda S.L.C.In this method, digital data is separated into two systems, and each is shifted by applying a digital bias in the + and - directions near the zero crossing point, essentially eliminating zero crossing distortion.In combination with a high-precision 20-bit D/A converter with a multi-bit method that converts to an analog signal at high speed, the dynamic range is greatly improved. Equipped with a digital input terminal, it can also be used as a D/A converter.Digital output can also be selected using the Output selector on the main unit. The pickup section uses a pickup that has a simple structure but demonstrates high performance.This, combined with the adoption of a hybrid loader structure that thoroughly suppresses vibration, achieves accurate signal reading. In addition, by reducing the number of parts, we have improved tracing accuracy and improved durability and reliability. In order to prevent deterioration of sound quality due to the influence of digital signals, in addition to thoroughly separating the digital and analog circuits, we have also separated the transformer and the board. The digital system is compactly organized to minimize interference with the analog system. In addition, a copper-plated chassis with high conductivity is used to suppress the impact of electromagnetic waves on the sound. A digital servo is used for the servo circuit.The optimal servo amount is detected for each disc and adjusted to match the disc. We use carefully selected ICs such as D/A converters, resistors, capacitors, and wiring materials.In addition, we use a detachable, extra-thick AC cord made of OFC wire for the power cable.A wireless remote control is included.
Live search