Musical Fidelity KW550 INPUT CONNECTIONS Phono: The KW550 has a pair of RCA type phono input sockets intended for use with moving magnet (MM) or moving coil (MC) pickups. Some turntable/pickup arm combinations are fitted with an extra wire for chassis earth. This should be connected to the earth terminal on the back panel. Line level inputs: The unit also has five stereo pairs of RCA “line level” input sockets controlled by the internal volume setting. They all have the same input sensitivity, and are therefore suitable for use with any source component having a line output of 300mV nominal. The sockets on the rear panel are marked, CD, AUX 1, AUX 2, AUX 3 and TAPE corresponding with function selector buttons on the front panel. The AUX1 input sockets on the back share the same input as the PDI input jack at the front. Do not connect devices to both the AUX 1 and PDI inputs simultaneously. Please see note P.11 OUTPUT CONNECTIONS Speakers: Connect your loudspeakers to the terminals on the back panel marked as LEFT and RIGHT SPEAKER outputs. Make sure both speakers are connected with the same polarity. PRE-: The KW550 has its pre-amplifier output available from RCA sockets on the back panel marked PRE-OUT, and is controlled by the volume adjustment. This is to allow “bi-amplification” using suitable external amplifiers and crossover networks to power the speaker drive components separately, giving noticeable improvement in clarity, imaging and bass weight. In this arrangement, typically the KW550 speaker outputs may be used to drive the speaker’s “tweeter” (high audio frequencies), and an external higher power stereo amplifier(s) could drive the “woofer” (low frequencies). ( note for duncan this is located with j wain) Musical Fidelity KW550 INPUT CONNECTIONS Phono: The KW550 has a pair of RCA type phono input sockets intended for use with moving magnet (MM) or moving coil (MC) pickups. Some turntable/pickup arm combinations are fitted with an extra wire for chassis earth. This should be connected to the earth terminal on the back panel. Line level inputs: The unit also has five stereo pairs of RCA “line level” input sockets controlled by the internal volume setting. They all have the same input sensitivity, and are therefore suitable for use with any source component having a line output of 300mV nominal. The sockets on the rear panel are marked, CD, AUX 1, AUX 2, AUX 3 and TAPE corresponding with function selector buttons on the front panel. The AUX1 input sockets on the back share the same input as the PDI input jack at the front. Do not connect devices to both the AUX 1 and PDI inputs simultaneously. Please see note P.11 OUTPUT CONNECTIONS Speakers: Connect your loudspeakers to the terminals on the back panel marked as LEFT and RIGHT SPEAKER outputs. Make sure both speakers are connected with the same polarity. PRE-: The KW550 has its pre-amplifier output available from RCA sockets on the back panel marked PRE-OUT, and is controlled by the volume adjustment. This is to allow “bi-amplification” using suitable external amplifiers and crossover networks to power the speaker drive components separately, giving noticeable improvement in clarity, imaging and bass weight. In this arrangement, typically the KW550 speaker outputs may be used to drive the speaker’s “tweeter” (high audio frequencies), and an external higher power stereo amplifier(s) could drive the “woofer” (low frequencies).  ( note for duncan this is located with j wain) Pictures sell! Auctiva offers Free Image Hosting and Editing. The complete eBay Selling Solution.