Parting one of my line arrays. Price is for the pair. All tweeters are working perfectly. I have 5 pairs total.

This Fountek ribbon is a well-known winner in the Price vs. Performance Sweepstakes. US New Retail price is about $125 each. The Fountek NeoCD3.0 is a true ribbon tweeter featuring an 8 x 60mm diaphragm, a high power neodymium magnet and a 110mm circular alloy faceplate. The ribbon material is an ultra light (10mg) multilayer aluminum sandwich with a cross section of 0.015mm (approx 0.6 thou). This medium sized ribbon tweeter has a high sensitivity of 93 dB and a broad operating range of between 1.4 kHz to 40 Khz. The end tensioning clamps form a substantial heatsink for the low impedance ribbon and an impedance matching transformer is built into the back of the housing. Representing an excellent price / performance / size ratio, this tweeter has been used in various high end designs. Fountek recommends a minimum crossover frequency of 2.5kHz @ 18db/octave. Key Features: Smooth extended response 1.4-40kHzUltra lightweight ribbonNeodymium magnet systemBuilt in transformerLow distortionExcellent transientsHigh efficiency output Basic parameters: Frequency range 1.4-40kHz Nominal impedance (Zn) 7 ? Ribbon dimensions 60x8mm DC resistance (Ribbon) 0.02 ? Effective area (squared) 480mm RMS power handling 17 W Crossover frequency 2.5kHz/18db Peak power 40 W Sensitivity (2.83V/1m) 93dB Faceplate (diameter) 110mm On Dec-07-23 at 11:23:10 PST, seller added the following information: Please see my other auction for an SB Acoustics 4-inch coaxial driver PLUS assembled Madisound crossover boards. Thanks, John

1 Paar Fountek Neo Pro 5i Bändchen Hochtöner. Leichte Gebrauchsspuren an den Schraublöchern siehe Fotos. Sonst guter Zustand. Weitere Infos hier: https://www.lautsprechershop.de/pdf/fountek/neopro5i.pdf

Fountek NeoCD3.0 3 Ribbon Tweeter [ $250.00 per pair retail price ]Super strong Neodymium magnetsBuild-in impedance conversion transformerEffective from 1,400Hz upwards due to the large diaphragm area and low self-resonance.Thin enforced sandwich ribbon diaphragm guarantees a high degree of signal fidelity and broad frequency response.Low distortion factor, good power-handling capabilities, high linear impedance and amplitude frequency response and the broad frequency response range.Flat impedance from 1,000 to 40,000Hz Warning:Ribbon tweeters should always be used with a passive crossover! They are a dead short to the amplifier.Do not test without a capacitor. Do not use an electronic crossover without a capacitor (we use 20+ mfd).Tweeters are repairable at Madisound for a very reasonable price. Call us to make arrangements.

Fountek NeoCD3.0 3 Ribbon Tweeter [ $250.00 per pair retail price ]Super strong Neodymium magnetsBuild-in impedance conversion transformerEffective from 1,400Hz upwards due to the large diaphragm area and low self-resonance.Thin enforced sandwich ribbon diaphragm guarantees a high degree of signal fidelity and broad frequency response.Low distortion factor, good power-handling capabilities, high linear impedance and amplitude frequency response and the broad frequency response range.Flat impedance from 1,000 to 40,000Hz Warning:Ribbon tweeters should always be used with a passive crossover! They are a dead short to the amplifier.Do not test without a capacitor. Do not use an electronic crossover without a capacitor (we use 20+ mfd).Tweeters are repairable at Madisound for a very reasonable price. Call us to make arrangements.

1 Pair Fountek NeoCD1.0 Ribbon Tweeters. These Tweeters require knowledge and understanding of proper implementation. If the drivers are installed incorrectly, damage is assured! TheseMusthave the proper order crossover (LR3), and most importantly, the proper crossover frequency (3,500hz 3rd order minimum). If you do not understand what the previous statement means, THESE ARE NOT FOR YOU! These type True Ribbon Tweeters need capacitors for diaphragm protection. Ribbon tweeters appear as a dead short to the amplifier without the crossover. Always use a capacitor in series while testing or with an active crossover. The Ribbon itself weighs only 10 Milligrams. So, the diaphragm is very fragile, simply blowing on it can damage it. These are some of the speakers bought from a speaker-building company that went out of business years ago. The drivers are new and unused, but the boxes look like hell from being moved around a dusty/dirty warehouse over the years. The drivers are new and look pristine! If you have any questions about the photos, please feel free to ask

Truly excellent condition. Basically new. As seen in pics the tweeters have their own custom enclosures. Beautifully made. Real wood veneer. Purchased and built for the extra Sparkle in a single driver folded horn speaker project that just never happened......just too busy with work and family. Tweeters were originally 278.00 each. I had the enclosures built for 150.00. I have quite a bit invested here. Id like to recover as much as possible but want to be realistic. I am asking 350.00 for the set with the enclosures. They come from a smoke free/pet free home. Will be packaged with great care.

1 Pair Fountek NeoCD1.0 Ribbon Tweeters. These Tweeters require knowledge and understanding of proper implementation. If the drivers are installed incorrectly, damage is assured! TheseMusthave the proper order crossover (LR3), and most importantly, the proper crossover frequency (3,500hz 3rd order minimum). If you do not understand what the previous statement means, THESE ARE NOT FOR YOU! These type True Ribbon Tweeters need capacitors for diaphragm protection. Ribbon tweeters appear as a dead short to the amplifier without the crossover. Always use a capacitor in series while testing or with an active crossover. The Ribbon itself weighs only 10 Milligrams. So, the diaphragm is very fragile, simply blowing on it can damage it. These are some of the speakers bought from a speaker-building company that went out of business years ago. The drivers are new and unused, but the boxes look like hell from being moved around a dusty/dirty warehouse over the years. The drivers are new and look pristine! If you have any questions about the photos, please feel free to ask

Good used working and cosmetic condition. Smooth extended response 1.4-40kHzUltra lightweight ribbonNeodymium magnet systemBuilt in transformerLow distortionExcellent transientsHigh efficiency output

1 Pair Fountek NeoCD1.0 Ribbon Tweeters. These Tweeters require knowledge and understanding of proper implementation. If the drivers are installed incorrectly, damage is assured! TheseMusthave the proper order crossover (LR3), and most importantly, the proper crossover frequency (3,500hz 3rd order minimum). If you do not understand what the previous statement means, THESE ARE NOT FOR YOU! These type True Ribbon Tweeters need capacitors for diaphragm protection. Ribbon tweeters appear as a dead short to the amplifier without the crossover. Always use a capacitor in series while testing or with an active crossover. The Ribbon itself weighs only 10 Milligrams. So, the diaphragm is very fragile, simply blowing on it can damage it. These are some of the speakers bought from a speaker-building company that went out of business years ago. The drivers are new and unused, but the boxes look like hell from being moved around a dusty/dirty warehouse over the years. The drivers are new and look pristine! If you have any questions about the photos, please feel free to ask

1 Pair Fountek NeoCD1.0 Ribbon Tweeters. These Tweeters require knowledge and understanding of proper implementation. If the drivers are installed incorrectly, damage is assured! TheseMusthave the proper order crossover (LR3), and most importantly, the proper crossover frequency (3,500hz 3rd order minimum). If you do not understand what the previous statement means, THESE ARE NOT FOR YOU! These type True Ribbon Tweeters need capacitors for diaphragm protection. Ribbon tweeters appear as a dead short to the amplifier without the crossover. Always use a capacitor in series while testing or with an active crossover. The Ribbon itself weighs only 10 Milligrams. So, the diaphragm is very fragile, simply blowing on it can damage it. These are some of the speakers bought from a speaker-building company that went out of business years ago. The drivers are new and unused, but the boxes look like hell from being moved around a dusty/dirty warehouse over the years. The drivers are new and look pristine! If you have any questions about the photos, please feel free to ask

2 x Fountek Neo CD3.0 Ribbon Tweeters (one pair) Full working order. Tested and Guaranteed.Excellent cosmetic condition They come with the matching Cross-overs (photos to be added shortly) PaymenteBay, Bank Transfer, or Cash on Collection ShippingCollection from Bristol BS7 - FreeUK Mainland from £9.90France, Germany, and most of Europe from £19.90Rest of the World from - Please ask Please Note: A signature is required on delivery Non UK Customers - ImportantVAT, Import Tax, or Customs Duty may be payable Please check. It is the buyers responsibility to pay these chargesThe full sale value of the goods will be declared on Customs Form*Returns*Returns are ONLY accepted if the item is faulty or is not as describedItems are checked, photographed, and security marked before shippingI am confident you will find the listing is accurate Thank you for looking