Description
Verkauft wird hier ein DANTE fähiger kleiner Class-D Verstärker mit max 2x 50 Watt sowie Line Out, kann also auch als reiner Dante/Analog Wandler dienen. Bis 96khz Sampling Rate. Keine Analogeingänge. Privatverkauf, keine Garantie oder Rücknahme Technische Daten: Audio Crosstalk >75 dB @ 1 kHz Audio input Number/signal type NetPA 502 AT 1 stereo or 2 mono NetPA 1001-70V AT 1 mono Connectors 1 RJ-45 Maximum level 0 dBFS (digital) Audio processing D/A conversion 24 bit, selectable sampling rate AT ports — audio transport Transmission Dante/AES-67, software selectable Connector 1 RJ-45 connector, 1-port 100 Mbps to Dante interface Inputs NetPA 502 AT 2 channels Rx NetPA 1001-70V AT 1 channel Rx Audio format 24-bit uncompressed, selectable at 44.1, 48, 88.2, and 96 kHz sampling rate Latency Deterministic, based on user selection: 2.0 ms (default), 5.0 ms Audio line output Number/signal type NetPA 502 AT 2 channels, balanced/unbalanced NetPA 1001-70V AT 1 channel, balanced/unbalanced Connectors NetPA 502 AT (1) 3.5 mm captive screw connector, 6 pole NetPA 1001-70V AT (1) 3.5 mm captive screw connector, 3 pole Impedance 50 ohms unbalanced, 100 ohms balanced Maximum level (at 0 dBFS digital input) >+15 dBu balanced; +9 dBu unbalanced Frequency response 20 Hz to 20 kHz, ±1 dB THD + Noise 0.03% @ 1 kHz at nominal level, 0.3% @ 20 kHz at nominal level S/N >90 dB, at maximum output (unweighted) NOTE 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ? 2 dBu Audio speaker output Number/signal type NetPA 502 AT 2 channels, 4 or 8 ohms NetPA 1001-70V AT 1 channel, 70 V Connectors NetPA 502 AT (1) 5.08 mm screw lock captive screw connector, 4 pole NetPA 1001-70V AT (1) 5.08 mm screw lock captive screw connector, 2 pole NOTE These connectors accept wires of 22 AWG to 12 AWG. Load impedance NetPA 502 AT 4 ohms minimum NetPA 1001-70V AT 50 ohms minimum Amplifier type Class D Output power NetPA 502 AT 50 watts rms per channel, 4 ohms, 1 kHz, 0.1% THD 25 watts rms per channel, 8 ohms, 1 kHz, 0.1% THD NetPA 1001-70V AT 100 watts rms, 70 V, 1 kHz, 0.1% THD Frequency response NetPA 502 AT 20 Hz to 20 kHz, +1/-3 dB @ 1 watt NetPA 1001-70V AT 20 Hz to 20 kHz, +1/-3 dB @ 1 watt THD + Noise <0.1% @ 1 kHz, 3 dB below clipping S/N >90 dB, 20 Hz - 20 kHz, unweighted High pass filter NetPA 1001-70V AT 80 Hz, 12 dB per octave rolloff for 70 V line output (switch selectable) Communications — amplifier Control port (1) 3.5 mm captive screw connector, 2 pole Pin configurations Standby power control (contact closure) Pin 1 = standby, pin 2 = Gnd General Power supply Internal Input: 100-240 VAC, 50-60 Hz, 0.5 A Power consumption and thermal dissipation NetPA 502 AT 115 VAC, 60Hz230 VAC, 50Hz AC Line CurrentAC Power ConsumedThermal DissipationAC Line CurrentAC Power ConsumedThermal Dissipation/ ConditionAWWBTU/hrAWWBTU/hr Active (1/8 power), all channels driven8?0.314.68.3280.21710.736 4?0.422.39.8330.32411.740 Quiescent (idle)0.17.47.4250.19.99.934 Standby<0.1<2<2<6<0.1<2<2<6 NetPA 1001-70V AT 115 VAC, 60Hz230 VAC, 50Hz AC Line CurrentAC Power ConsumedThermal DissipationAC Line CurrentAC Power ConsumedThermal Dissipation ConditionAWWBTU/hrAWWBTU/hr Active (1/8 power), all channels driven70 V0.422.710.2350.324.111.639 Quiescent (idle)0.17.67.6260.19.29.231 Standby<0.1<2<2<6<0.1<2<2<6 Ambient temperature/humidity Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +104 °F (0 to +40 °C) / 10% to 90%, noncondensing Cooling Convection, no vents, with internal heat sink Protection Clip limiting, thermal, short circuit, DC output Indication Limiter/Protect LED indicates the onset of clip limiting, thermal cycling, or short circuit Mounting Rack mount Yes, with optional 1U rack shelf Furniture mount Yes, with optional under-desk mounting kit Enclosure type Metal Enclosure dimensions 1.7 H x 8.7 W x 9.5 D (1U high, half rack wide) (4.3 cm H x 22.1 cm W x 24.1 cm D) Product weight NetPA 502 AT 2.6 lbs (1.2 kg) NetPA 1001-70V AT 2.6 lbs (1.2 kg) Regulatory compliance BSEN 60065, CE, C-tick, c-UL, EN 55103-1, EN 55103-2, ENERGY STAR®, FCC Class B, ICES, IEC 60065, RoHS, UL, UL 60065, VCCI Class B, WEEE. Product warranty 3 years parts and labor Everlast power supply warranty 7 years parts and labor NOTE All nominal levels are at ±10%. NOTE Specifications are subject to change without notice.
Live search