This is a vintage Aurex/Toshiba SR-510, top model for that time, tested and working as it should, only issue is 33 1/3 rpm indicator light is out. This was originally offered without a tonearm, it was made and designed so tonearm of your choice can be added, currently has high end Toshiba tonearm, although i had a hard time pinpointing exactly which tonearm it is. This is not the same tonearm as the other SR-510 currently listed, I think that one looks similar to Tonearm offered on SR-410. Plinth has been touched up with new stain and feet have been replaced, but they are still individually adjustable, tonearm is adjustable as well. Has indicator lights for proper speed, as well as one each for fast and slow drive speeds. Switching between 33 1/3 and 45 rpm is done with light touch of buttons located to left of strobo and speed indicator, this turntable also comes with built-in level so you can easily know if its setup properly or one needs to adjust feet. Comes with original headshell and cartridge, needs new stylus Specs from the web: TypeRecord player MotorAC servo motor Drive systemDirect drive system Number of revolutions33 1/3, 45 rpm Wow flutter0.03%(WRMS) Signal-to-noise ratio60dB Turntable30 cm Aluminum Die-cast, 1.2 kg Inertial mass170kg-cm2 Tone Arm Section TypeStatic Balance S-shaped Effective length237mm Tracking error+ 1.5 °, -0.5 ° Overhang15mm Needle pressure variable range0 ~ 4g Cartridge Section TypeElectret Condenser Type (C-404X) Frequency characteristic25 Hz to 50 kHz Output voltage30 mv (1 khz, 50mm/s) Separation25dB(1kHz) 15dB(30kHz) Channel balance1dB(1kHz) Compliance15x10-6cm/dyne Recommended load resistance30k ? or more Supplied DC voltage6 v ~ 9 v Needle tipExtended needle Needle pressure1.5g Exchange needleN-404C-EX(¥7,000) N-404X(¥13,000) Dead weight4.5g Pwer100 VAC, 50Hz/60Hz Power consumption14W External dimensionsWidth 550x Height 190x Depth 414 mm Weight12kg