Auction is for a partially working Parasound HCA-2200. Unit turns on, passes sound to speakers. But when turning volume up on the line level device, it starts cutting out, and the standby slowly flashes. (OL lights do not engage) A few components on the boards need to be replaced as seen in pictures. This unit is being sold as parts regarless of its current operating status.

This is a good unit and in working order. That said it is older and it can do with a refresh I’m sure. Because of the age of the unit there are no promises made or given about the long term function of the amp. It is running the fronts on my Home Theater now pushing Gallo speakers. So I am sure it works. If it arrives and there is obvious damage to the packaging. Take pictures. I cannot accept a return without those pictures. Pictures of the damage to the amp and whatever functionality was lost. I love this piece. I’m moving though and I can’t take it with me. I have too much stuff. Check out the information below. See that you are getting an insane amp. It was 1700 new in 96. That is almost 4K in 24 dollars. You can’t buy a better amp for less than 3k new. Even today. Max Power Supply 1320 W!!!  200WPC into 8ohms all channels >2db headroom 300WPC into 4ohms all channels >2db headroom • Designed by John Curl • THX certified by Lucasfilm Ltd. • Massive Encapsulated 1.2 kVA Power Transformer with Separate Windings for Each Channel • 90,000 uF Computer-grade Capacitors in the Power Supply • Multiple Polystyrene Film Bypass Capacitors to Smooth the Power Supply • Independent Power Supplies for Each Channel • Separate Regulated Power Supplies for Driver Stage • Cascode Class A Input Stages with Matched Complementary J-FET Pairs • Hand Picked Complementary MOSFETS in High Voltage Driver Stages • 12 Complementary Pairs of Beta-Matched 50 MHz, 15 Ampere Output Transistors • Output Transistors Direct-Coupled to Speakers Without LRC Networks • Linear Tracking, Instantaneous Acting DC Servos • High-Bias Class A/AB Operation • Gold-Plated Metal Structure RCA Input Jacks • Multiple Temperature Sensors and Silver-Cadmium Relay Protection • FR-4 Glass Epoxy Circuit Boards, Double-Sided for Precision https://parasound.com/pdfs/vintage/hca2003om.pdf

Verkaufe meine Parasound Studio Endstufe, da Sie schon seit Jahren nicht mehr verwendet wird.( Ich höre nur noch Nahfeld ... ) Arbeitet zuverlässig mit tollem Sound. Alle Relais schalten zuverlässig.Hohe Leistung ( 2 x 205 Watt RMS an 8Ohm ), ohne nervenden Lüfter-Lärm.Für gute Luftzirkulation sollte allerdings gesorgt sein !Besonders bei 19-Rack Einbau.THX certifiziert.Auch für HiFi Anwendung bestens geeignet. Mit kräftigem, trockenem Bass und feinen Höhen.Specs :Continuous Power Output - Stereo :205 watts RMS x 2, 20Hz-20kHz, 8 ?, both channels driven315 watts RMS x 2, 20Hz-20kHz, 4 ?, both channels drivenContinuous Power Output - Mono :625 watts RMS, 20Hz-201kHz, 8 ?Current Capacity :40 amperes continuous57 amperes peakSlew Rate :>130V/µsecondFrequency Response :8Hz-150kHz, +0/-3dB at 1 wattTotal Harmonic Distortion :< 0.06% at full power< 0.03% typical levelsTIM :UnmeasurableIM Distortion :< 0.04%S/N Ratio :> 110dB, input shorted, IHF A weightedDamping Factor :> 600 at 20HzDimensions :19 wide x 5.5 high x 13 deepWeight :37 lbs. net

This is a collectors item original review from 1994! Geat for collectors and audiophiles! These are vintage RARE ads for Great Audio and Video Equipment. Check out my Ebay Store for THOUSANDS more relating to electronics. ready for framing and put on your wall! 100% original, no copies or reproductions. I ship Worldwide! Shipping is $3 in USA,$6 elsewhere. -These ads look great framed or put in a binder, they can also add value when selling your equipment as many of them have specs and details about the audio equipment! -Please email for any questions. Check out my Ebay Store, ELECTRONICS ARCHIVES, for many more vintage ads! -Shipping discounts are given for additional items, It is $3 for your first item in USA,$6 international, then just $1 for each additional item! -All our ads are 100% ORIGINAL! They are from the year they are listed as. -Satisfaction guaranteed! THANKS! ELECTRONICS ARCHIVES Powered by eBay Turbo Lister The free listing tool. List your items fast and easy and manage your active items.

Parasound HCA-1200II Two Channel Power Amplifier THX (TEST WORKS GREAT) P.S LOOK AT THE PICTURES FOR THE CONDITION CONES AS IS WITH EVERYTHING IN THE PHOTOS

PREOWNED - $3200 LIST! - FULLY TESTED - INCLUDES ORIGINAL REMOTE, POWER CABLE - *COAX-IN IS NOT WORKING*Preamp and DAC Features Latest generation ESS Sabre32 Reference DAC (ES9018K2M) Asynchronous USB 2.0 supports PCM up to 384kHz/32-bit USB input decodes Native DSD64, DSD128, DSD256 and DoP DSD Windows USB drivers for ASIO & WASAPI Mac OS does not require any drivers optical accept PCM up to 192kHz/24-bit Analog bass management with high & low pass crossovers Home theater bypass input for surround sound integration Front panel subwoofer level control Dedicated high current headphone amplifier (TI TPA6120) Phono for MM & MC with 100 ? or 47k ? load Front panel Aux input with automatic +12 dB gain stage 5 pairs RCA line level Analog inputs 1 pair XLR balanced Analog input Balanced XLR and RCA left and right preamp outputs 1 balanced XLR and 2 RCA subwoofer outputs Bass & treble controls with relay bypass from remote or front panel Rear panel IR input and IR loop output jacks 12 Volt input and output to triggers Back-lit remote control with discrete buttons 0.5w standby power consumption meets Energy Star & EU specs Power Amp Features 160 Watts x 2 @ 8 Ohms (RMS, both channels driven) 240 Watts x 2 @ 4 Ohms (RMS, both channels driven) Power amp circuit topology designed by legendary John Curl Direct amplifier input to bypass preamp section High bias class A/AB operation Oversized shielded toroid power transformer Dual-mono power supply and power amplifier 40,000uF power supply filter capacitance Matched JFET input stages and MOSFET driver stages 12 high voltage/high current bipolar output transistors Heavy-duty 24k gold-plated 5-way speaker binding posts Over temp and short circuit relay protection Power Output - Both channels driven(0.05% THD, RMS, 20 Hz - 20 kHz)160 watts x 2 @ 8 ?240 watts x 2 @ 4 ? Power Output - Both channels driven(0.9% THD, RMS, 20 Hz - 20 kHz)180 watts x 2 @ 8 ?270 watts x 2 @ 4 ? Current Capacity45 amps peak per channel Frequency Response10 Hz - 100 kHz, +0/-3 dB Total Harmonic Distortion (THD)< 0.01 %, average listening levels< 0.05 %, 160 watts x 2 @ 8 ? Interchannel Crosstalk> 50 dB at 20 kHz> 70 dB at 1 kHz Signal to Noise Ratio - IHF A-weightedLine in: - 103 dB (input shorted)Digital in: - 106 dB Amplifier Damping Factor> 800 at 20 Hz Preamp Stage Input Sensitivity300 mV in for 1 V at Pre Out jacksTotal Preamp Stage Gain: 10 dBMax Output Unbalanced: 7 VMax Output Balanced: 9 V Power Amplifier Stage Sensitivity1 V at Bypass/Amp In for 28 V at Speaker OutTotal Amp Stage Gain: 28 dB Phono Stage Sensitivity / Input Impedance Input ImpedanceMM: 35 dB / 47 k ?MC: 52 dB / 47 k ? or 100 ? Input Capacitance150 pF High & Low Pass Crossover Slopes12 dB per octave Supported DAC Sampling Rates USB: up to 384 kHz / 32-bit PCMDSD Native: DSD 64, DSD 128, DSD 256DSD over PCM (DoP) at 384 kHz Opt: up to 192 kHz / 24-bit PCM Digital to Analog ConverterESS Sabre32 Reference ES9018K2M384 kHz / 32-bit USB 2.0 ControllerVIA VT1731, 384 kHz / 32-bit Headphone AmplifierTexas Instruments TPA6120AOutput Impedance 10 ohms XLR Pin Identification1 = Ground (Shield)2 = Positive3 = Negative (Return) Input ImpedanceUnbalanced: 24 k ?Balanced: 100 k ? per leg Output ImpedanceUnbalanced: 100 ?Balanced: 470 ? per leg DimensionsWidth: 17-1/4 (437 mm)Depth: 16-1/4 (413 mm)Depth, with cables 17-1/4 (437 mm)Height, with feet: 5-7/8 (150 mm)Height, without feet: 5-1/4 (133 mm), 3U Net Weight33 lb. (15 kg) Shipping Weight 45 lb. (20.4 kg) Hi-Fi Heaven1549 Sixth StGreen Bay, WI 54304Contact us with your exact shipping address for accurate shipping cost.Larger speakers and items over 150lbs are strapped to a pallet and shipped via Freight including liftgate and residential delivery.We accept Pay-Pal or credit cards by contacting our store.We offer a 4% discount with payment by Zelle or check.Defective items are exchanged within 14 days from delivery.After 14 days, the manufacturers warranty will apply. Contact us for any assistance in obtaining warranty assistance.Defective item returns must be in the manufacturers original packaging, in like-new condition, including all packaging materials, shipped as-received and fully insured.Items are guaranteed to be as described.If a refund is desired, we will refund your full purchase price minus a 20% restocking fee.The item must be as received & unopened. Buyer pays return shipping costs.If you are having a problem, Please call before making a return claim on eBay.We do not offer free auditions or trials of merchandise.Returns will only be accepted for items that are truly defective.We use methods to detect product tampering.We will seek legal action against any individual or entity attempting to defraud us.Hi-Fi Heaven1549 Sixth StGreen Bay, WI 54304

This is a good unit and in working order. That said it is older and it can do with a refresh I’m sure. Because of the age of the unit there are no promises made or given about the long term function of the amp. It is running the fronts on my Home Theater now pushing Gallo speakers. So I am sure it works. If it arrives and there is obvious damage to the packaging. Take pictures. I cannot accept a return without those pictures. Pictures of the damage to the amp and whatever functionality was lost. I love this piece. I’m moving though and I can’t take it with me. I have too much stuff. Check out the information below. See that you are getting an insane amp. It was 1700 new in 96. That is almost 4K in 24 dollars. You can’t buy a better amp for less than 3k new. Even today. Max Power Supply 1320 W!!!  200WPC into 8ohms all channels >2db headroom 300WPC into 4ohms all channels >2db headroom • Designed by John Curl • THX certified by Lucasfilm Ltd. • Massive Encapsulated 1.2 kVA Power Transformer with Separate Windings for Each Channel • 90,000 uF Computer-grade Capacitors in the Power Supply • Multiple Polystyrene Film Bypass Capacitors to Smooth the Power Supply • Independent Power Supplies for Each Channel • Separate Regulated Power Supplies for Driver Stage • Cascode Class A Input Stages with Matched Complementary J-FET Pairs • Hand Picked Complementary MOSFETS in High Voltage Driver Stages • 12 Complementary Pairs of Beta-Matched 50 MHz, 15 Ampere Output Transistors • Output Transistors Direct-Coupled to Speakers Without LRC Networks • Linear Tracking, Instantaneous Acting DC Servos • High-Bias Class A/AB Operation • Gold-Plated Metal Structure RCA Input Jacks • Multiple Temperature Sensors and Silver-Cadmium Relay Protection • FR-4 Glass Epoxy Circuit Boards, Double-Sided for Precision https://parasound.com/pdfs/vintage/hca2003om.pdf