Excellent quality Pr Scanspeak D2905/970000 Dome Textile tweeters. They are nominal 6 ohms, both measure 5.5 ohms. See the impressive specs below. They are in nice working condition, a few of the screw holes show some wear, nothing serious. They were always in a non smoking climate controlled environment. The shipping cost includes safe packing, insurance, prompt shipping and tracking number. They were quality made and designed in Denmark, incomparable quality design, craftsmanship and performance. Buy with confidence, see my feedback. Good listening, SonnY :) ScanSpeak Classic D2905/970000 1? Tweeter Textile Dome1? Textile Dome DiaphragmPatented Symmetrical Drive (SD-2) motorFrequency Extension to above 30KHzLow Resonance Rear ChamberBlack Painted Alu Face Plate The Scan-speak D2905-970000 uses the same hand coated dome and voice coil of the D2905/9500, but uses the motor system of the Revelator. The Symmetric Drive technology eliminates almost all electrical phase shift. The carefully machined top plate minimize air noise and compression. Copper caps act as heat conductors. High power handling is achieved without ferrofluid and improves micro-dynamic linearity. The tweeter has excellent dynamic and detailing capability. PDF 28 mm Dome Tweeter 6 ohm, Ferrite Magnet, Non-Resonant Chamber - 1 Textile Dome Diaphragm - Patented Symmetrical Drive (SD-2) motor - Frequency Extension to above 30KHz - Low Resonance Rear Chamber - Black Painted Alu Face Plate

This Scan-Speak D2008/851200 tweeter is a must-have for any audiophile looking to upgrade their sound system. With its high-quality construction and superior performance, this speaker driver is sure to impress even the most discerning listener. Crafted by one of the most respected brands in the industry, this Scan-Speak tweeter delivers clear and powerful sound with every use. Perfect for use in home audio and hi-fi separates, this model is designed to fit seamlessly into your existing setup. So why wait? Upgrade your sound system today with this top-of-the-line speaker driver! Ideal replacement for Linn speakers Tested and working I do have a pair but the other one no sound so will send to winning bidder for free

Used but sound Beautiful taken From QLN speakers as they were upgraded .

Scanspeak D2008/851100 Tweeters One working, one faulty - pictures to be updating showing impedance. Removed from a pair of Naim Allae speakers (replaced with a matched pair from the very last production run of this model)

Naim Allae speakers with brand new 1:1 replacement Scanspeak D2008/851100 Tweeters fitted (matched pair) Includes original boxes, floor spikes, standoffs/pegs & Naim speaker cable (designed for use with Naim amplifiers) Would ideally sell as a set (with a bundle deal) - see my other Naim listings for NAC62 & NAP140 and CD5i.

SCANSPEAK Tweeter from Wilson Audio oem parts. These were from a Wilson audio speaker, they are in great condition, and sound amazing, see measurments, perfectly flat from 3k to 15k, an incredible device, also they show close matching as you can see in the graph where ones curve is in red. Excellent état et fonctionnement comme en attestent les mesures, réponse excellente de 3k à 15k, c est un tweeter exceptionnel fabriqué par Scanspeak pour Wilson Audio Idéal pour une enceinte 2 ou 3 voies

Linn Ninka Floor Standing Speakers with Scanspeak Tweeters. Excellent working order although the cabinets do have a few marks (and which could probably be touched up) - and a small chip in the top right corner of one of the speakers. I have tried to highlight in the photos. I have replaced and upgraded the tweeters with the Scanspeak D2008/851200 from Falcon Acoustics Collection from Crouch End, N8

NOS tweeter MISSION D19 per serie 7 (tipo SCANSPEAK DYNAUDIO PROAC). Tweeter MISSION D19 con cupola morbida da 19mm utilizzato su buona parte della famosa serie 7XX, quella che di fatto ha reso famoso il marchio Inglese. Entrambi i tweeter sono assolutamente originali e praticamente nuovi in quanto erano fondi di magazzino per ricambio (diametro flangia 94mm). Usati solo una volta su un diffusore Mission 760 per verificarne il perfetto funzionamento. Prezzo alla coppia.

THIS TWEETERS ARE VERY HIGH QUALITY HI-END, MADE FOR AVLON ACOUSTICS. These PAIR of tweeters extend beyond 40KHz with a very good frequency response and really heavy. The Norminal RMS is 120 WATTS on 8Ohms (check the technical SPL vs Freq. graph) According to sources, they were designed by Avlon Acoustic and they abundant it because it was alleged the company claimed it was too expensive and opted for a cheaper version. Just look at the size of the magnet, so big like a Hi-End midrange drive and they very heavy too. Over 1kg in weight. Compare it in size to the Scanspeak illuminator tweeters in the photos? take the chance to grab a bargain. I have come by a box and are in stock so contact me if you are interested on 07930498660 .

SCANSPEAK Tweeter from Wilson Audio oem parts. These were from a Wilson audio speaker, they are in great condition, and sound amazing, see measurments, perfectly flat from 3k to 15k, an incredible device, also they show close matching as you can see in the graph where ones curve is in red. Excellent état et fonctionnement comme en attestent les mesures, réponse excellente de 3k à 15k, c est un tweeter exceptionnel fabriqué par Scanspeak pour Wilson Audio Idéal pour une enceinte 2 ou 3 voies

2 SCANSPEAK TWEETERS D2008/851100 8 OHM. I collected the and the seller told me hed taken from his Naims having had them from new. I have not used during the 2 years since then. Classic range but now replaced with some costing about 150. Before then they were in the range over 30 years. Bumf says power 90W Sensitivity 89db Faceplate 92mm Crossover suggestion 4KHz (2nd order) DC continuity.6.5/6.4 Ohms Buyer pays any duties charged in delivery jurisdiction

Naim Allae speakers with brand new 1:1 replacement Scanspeak D2008/851100 Tweeters fitted (matched pair) Includes original boxes, floor spikes, standoffs/pegs & Naim speaker cable (designed for use with Naim amplifiers) Would ideally sell as a set (with a bundle deal) - see my other Naim listings for NAC62 & NAP140 and CD5i.

Linn Ninka Floor Standing Speakers with Scanspeak Tweeters. Excellent working order although the cabinets do have a few marks (and which could probably be touched up) - and a small chip in the top right corner of one of the speakers. I have tried to highlight in the photos. I have replaced and upgraded the tweeters with the Scanspeak D2008/851200 from Falcon Acoustics Collection from Crouch End, N8

SCANSPEAK Tweeter from Wilson Audio oem parts. These were from a Wilson audio speaker, they are in great condition, and sound amazing, see measurments, perfectly flat from 3k to 15k, an incredible device, also they show close matching as you can see in the graph where ones curve is in red. Excellent état et fonctionnement comme en attestent les mesures, réponse excellente de 3k à 15k, c est un tweeter exceptionnel fabriqué par Scanspeak pour Wilson Audio Idéal pour une enceinte 2 ou 3 voies

Scanspeak D2008 tweeter in good working order.Suitable for use in Proac Tablette Linn Kan etc Few small dents in the domePlease see photos.

Linn Ninka Floor Standing Speakers with Scanspeak Tweeters. Excellent working order although the cabinets do have a few marks (and which could probably be touched up) - and a small chip in the top right corner of one of the speakers. I have tried to highlight in the photos. I have replaced and upgraded the tweeters with the Scanspeak D2008/851200 from Falcon Acoustics Collection from Crouch End, N8

SCANSPEAK Tweeter from Wilson Audio oem parts. These were from a Wilson audio speaker, they are in great condition, and sound amazing, see measurments, perfectly flat from 3k to 15k, an incredible device, also they show close matching as you can see in the graph where ones curve is in red. Excellent état et fonctionnement comme en attestent les mesures, réponse excellente de 3k à 15k, c est un tweeter exceptionnel fabriqué par Scanspeak pour Wilson Audio Idéal pour une enceinte 2 ou 3 voies

THIS TWEETERS ARE VERY HIGH QUALITY HI-END, MADE FOR AVLON ACOUSTICS. These PAIR of tweeters extend beyond 40KHz with a very good frequency response and really heavy. The Norminal RMS is 120 WATTS on 8Ohms (check the technical SPL vs Freq. graph) According to sources, they were designed by Avlon Acoustic and they abundant it because it was alleged the company claimed it was too expensive and opted for a cheaper version. Just look at the size of the magnet, so big like a Hi-End midrange drive and they very heavy too. Over 1kg in weight. Compare it in size to the Scanspeak illuminator tweeters in the photos? take the chance to grab a bargain. I have come by a box and are in stock so contact me if you are interested on 07930498660 .

Naim Allae speakers with brand new 1:1 replacement Scanspeak D2008/851100 Tweeters fitted (matched pair) Includes original boxes, floor spikes, standoffs/pegs & Naim speaker cable (designed for use with Naim amplifiers) Would ideally sell as a set (with a bundle deal) - see my other Naim listings for NAC62 & NAP140 and CD5i.

NOS tweeter MISSION D19 per serie 7 (tipo SCANSPEAK DYNAUDIO PROAC). Tweeter MISSION D19 con cupola morbida da 19mm utilizzato su buona parte della famosa serie 7XX, quella che di fatto ha reso famoso il marchio Inglese. Entrambi i tweeter sono assolutamente originali e praticamente nuovi in quanto erano fondi di magazzino per ricambio (diametro flangia 94mm). Usati solo una volta su un diffusore Mission 760 per verificarne il perfetto funzionamento. Prezzo alla coppia.

THESE SPECIAL SCANSPEAK TWEETERS MADE EXCLUSIVE TO GamuT COMES WITH A T/S OR >>>>>>>THE TECHNICAL DATA SHEET.>>>>>>> These are GamuT RS3i tweeters, a scanspeak made, exclusively for the GamuT which were used in their 14,000.00GBP GamuT RS3i stand-mount speakers. The magnet used in assembling these tweeters are specifically super strong ; graded N55, even stronger than the ones used in the Scanspeak R2904/700009 tweeters. These tweeters can only be obtained from the GamuT for over 500.GBP and you must have a prove of receipt of the RS3I and the serial numbers of the speakers before it willbe sold to you, so take the chance to grab a bargain. I have come by a box and are in stock so contact me if you are interested on 07387119542.

Linn Ninka Floor Standing Speakers with Scanspeak Tweeters. Excellent working order although the cabinets do have a few marks (and which could probably be touched up) - and a small chip in the top right corner of one of the speakers. I have tried to highlight in the photos. I have replaced and upgraded the tweeters with the Scanspeak D2008/851200 from Falcon Acoustics Collection from Crouch End, N8

SCANSPEAK Tweeter from Wilson Audio oem parts. These were from a Wilson audio speaker, they are in great condition, and sound amazing, see measurments, perfectly flat from 3k to 15k, an incredible device, also they show close matching as you can see in the graph where ones curve is in red. Excellent état et fonctionnement comme en attestent les mesures, réponse excellente de 3k à 15k, c est un tweeter exceptionnel fabriqué par Scanspeak pour Wilson Audio Idéal pour une enceinte 2 ou 3 voies

NOS tweeter MISSION D19 per serie 7 (tipo SCANSPEAK DYNAUDIO PROAC). Tweeter MISSION D19 con cupola morbida da 19mm utilizzato su buona parte della famosa serie 7XX, quella che di fatto ha reso famoso il marchio Inglese. Entrambi i tweeter sono assolutamente originali e praticamente nuovi in quanto erano fondi di magazzino per ricambio (diametro flangia 94mm). Usati solo una volta su un diffusore Mission 760 per verificarne il perfetto funzionamento. Prezzo alla coppia.