ECC807 Kept as a spare for my Rogers amp but never used and now selling the amp. Tested and works as a pre amp valve in my Rogers, but no idea how many hours of use its had in the past

Rogers HG88 Mk3 Valve Tube Amplifier With (faded) gold phono adaptor - MM Aesthetics: fairly good! A slight ding in the metal fascia near the Tape switch. See picture. Wooden sleeve is very presentable, the mesh grille on top is slightly wavy. Tiny chip in the wood laminate at the rear, so mainly out of sight. Original on/off toggle switch present and working. Light bulb working. Please note there is one missing 4BA bolt and washer which holds the amp inside the sleeve, two still remain. Amp is currently working but due to the nature of vintage valve hi-fi equipment Im selling the amp as working but in need of service/check over by a qualified engineer. The amp will be very well packaged, but a tiny solder joint for example could get dislodged in transit, which is why I insist on the above statement must be adhered to. Collection and/or demonstration is welcome in the NW10 area of London. I will ship using DHL tracked unless the buyer has a different preference All valves present and working. No modifications to speaker taps, etc. Has had some capacitors replaced in its lifetime along with Im sure other components. Please see photos to guage this and workmanship Please ask for any further information or photos

Vintage Rogers Cadet III Valve Amplifier, Classic British made Amplifier! Working order. Some scratches and marks and rusty due to the age, Please refer to all the photos for the condition. Heavy so collection in person preferred! UK mainland shipping only! Or overseas via eBay global shipping programme. Please have a look at my other items for sale. Thank you for looking.

Vintage Rogers Cadet III Valve Amplifier, Classic British made Amplifier! Working order. Some scratches and marks and rusty due to the age, Please refer to all the photos for the condition. Heavy so collection in person preferred! UK mainland shipping only! Or overseas via eBay global shipping programme. Please have a look at my other items for sale. Thank you for looking.

Rogers Cadet 111 vintage valve amplifier, was working 45 years ago until it developed a mains hum, it could have just been my leads but I obtained an alternative amplifier and stuck this one in the loft and forgot about it until recently. In good cosmetic condition, full set of valves mainly Mullards and Brima. Power output: 10 watts per channel into 8 (stereo). Frequency response: 20Hz to 20kHz. Total harmonic distortion: 0.8% Unable to test so sold as spares or repair. Please note that there is bubble wrap inside the amplifier to preotect the valves should they come loose during transit and it would be advisable to remove it before attempting to power up the amplifier. Thanks for looking!

Fantastic cadet III amplifier In good working condition please see video.Some of the electrolytic capacitors have Been done and the big cans have been changed as you can seeFrom the photos the new caps are underneath with the big ones disconnected the only reason these were left was at some point I was going to stuff the originals.The case as some scratches and chips to the Formica finish but this shows it’s life.As with most hifi from the 60s,70s I cannot guarantee that a month or two down the road one of the valves will go Etc but iv owned this for about 4 years and used it most weeks .Reluctant sale but we’re moving and down sizing.Any questions or more photos Etc please message.Thank you