Crestron AMP-2210HT 2x210W Professional Audio Amplifier, 4/8? or High-Power 70V. Condition:This Crestron AMP-2210HT has minor signs of use, including some surface scratches and scuffs. However, these cosmetic imperfections do not affect its functionality in any way. It has been well-maintained and thoroughly tested to ensure it performs at its best. Included:- Crestron AMP-2210HT 2x210W Professional Audio Amplifier- Power cable Audio Typical of 2 mono amplifier channels: Input Signal TypeBalanced or unbalanced analog line-level Output Signal Types4/8 Ohm or 70 Volt Output Power120 Watts at 8 Ohms;210 Watts at 4 Ohms;420 Watts at 8 Ohms bridged;210 Watts at 70 Volts[1] Damping Factor>100 ProtectionOver Current, Over/Under Voltage, Over Temperature, DC Offset Frequency Response20Hz to 20kHz ±0.5 dB at 4/8 Ohms;80Hz to 20kHz +0/-3 dB at 70 Volts THD0.05% @ 1kHz, full rated power at 4/8 Ohms, 8 Ohms Bridged, or 70/100 Volts;0.1% @ 20Hz to 20kHz, 120W at 8 Ohms;0.2% @ 20Hz to 20kHz, 210W at 4 Ohms;0.1% @ 20Hz to 20kHz, 420W at 8 Ohms Bridged;0.1% @ 80Hz to 20kHz, 210W at 70 Volts S/N Ratio>103 dB, A-weighted Crosstalk>70 dB @ 1kHz Gain23 dB with INPUT LEVEL control set at 12 oclock nominal position Input Sensitivity2.22 Vrms for rated output power with INPUT LEVEL control set at 12 oclock nominal position Input Detection Threshold40 mV RMS @ 1 kHz Input Level Adjustment±10 dB from nominalConnectors G6-32 screw, chassis ground lug INPUT CH 1 – 2(2) 3-pin 3.5mm detachable terminal blocks;Balanced/unbalanced line-level audio inputs;Input Level: 5.3 Vrms maximum with INPUT LEVEL control set at minimum position;Input Impedance: 24k Ohms balanced, 12k Ohms unbalanced SPEAKER OUTPUT CH 1 – 2(2) 4-pin 7.62mm 15A detachable terminal blocks;4?/8? and 70V power amplifier outputs;Wire Size: Terminals accept up to 14 AWG REMOTE(1) 6-pin 3.5mm detachable terminal block;Provides (2) remote control inputs; enables independent power control of each channel via local jumpers or remote contact closures;inputs may be safely paralleled for global control FUSE T6.3AH 250VMain fuse holder;5x20 mm, 250V, 6.3AH, time-lag, high-rupture rated 100-240V~50/60Hz(1) IEC C14 male chassis plugs, main power input;Mates with removable power cord (included)Controls & Indicators PWR(1) dual-color LED, green indicates ACTIVE state, yellow indicates STANDBY state INPUT 1 – 2, SIGNAL(2) green LEDs, indicate signal presence on each corresponding channel OUTPUT 1 – 2, CLIP(2) amber LEDs, indicate a clipping condition on each corresponding channel OUTPUT 1 – 2, FAULT(2) red LEDs; indicate over-temperature, over-current, over or under power supply voltage, or DC offset condition on each corresponding channel INPUT CH 1 – 2 LEVEL (rear)(2) Rotary input boost/attenuate adjustments w/center detent at nominal SPEAKER OUTPUT CH 1 – 2, 70V / 4/8? (rear)(2) 2-position slide switches, select the output configuration for each corresponding channel ON/REMOTE/OFF (rear)(1) 3-position slide switch; selects between all channels powered on, all channels powered off, or remote control of each individual channelPower Requirements Main Power100-240 Volts AC, 50/60 Hz Power Consumption62 Watts @ 8 Ohms, all channels driven at 1/8th output power;88 Watts @ 4 Ohms, all channels driven at 1/8th output power;89 Watts @ 70V, all channels driven at 1/8th output power;26 Watts, all channels idle;<1 Watt in standbyEnvironmental Temperature41° to 104°F (5° to 40°C) Humidity10% to 90% RH (non-condensing) Heat Dissipation110 BTU/Hr @ 8 Ohms, all channels driven at 1/8th output power;121 BTU/Hr @ 4 Ohms, all channels driven at 1/8th output power;125 BTU/Hr @ 70V, all channels driven at 1/8th output power;89 BTU/Hr, all channels idle;<3.4 BTU/Hr in standbyEnclosure ChassisMetal with black finish, vented top and sides, convection cooled Front PanelMetal, black finish with polycarbonate label overlay MountingFreestanding or 1U 19-inch rack-mountable (adhesive feet and rack ears included)Dimensions Height1.70 in (44 mm) Width17.28 in (439 mm);19.0 in (483 mm) with rack ears Depth14.59 in (371 mm)Weight 15.6 lb (7.1 kg)

Crestron AMP-2210T Commercial Power Amplifier????FREE-SHIPPING???? Item Is Used And Good Cosmetic Condition. If it is not in the picture it means it is not included. What you see in the pictures that is all you going to get.