Description
Onkyo Reference Series M-5000R Power Amplifier. New in Box. Original MSRP $4,198 This amp was set up for display and operated less than 4 running hours. NOTE: there is a small rub mark on the front top edge as shown on Photo 6 & 7. Almost imperceptible and barely visible. Photos taken with a flash to accentuate. Otherwise, amp is in good condition and in excellent working order. AWRAT (Advanced Wide Range Amplifier Technology) stereo power amplifier80 watts per channel into 8 ohms (20-20 kHz at 0.05% THD)150 watts per channel into 4 ohms (20-20 kHz at 0.05% THD)XLR mono Bridge input enables unit to be run in mono at 180 watts x 1 into 8 ohmsfrequency response: 10-100,000 Hz/0dB, -1 dB (1W)signal-to-noise ratio: 110 dBRCA inputs for each channel; mono XLR inputquad push-pull amplification design with 3-stage inverted Darlington circuitry to reduce distortiontwo massive toroidal power transformers and four 27,000-microfarad capacitors for stable, instantly available high currentclosed ground-loop circuits keep individual circuit noise and ground potential interference to a minimumtotally symmetrical alignment of power devices for left and right channels reduces chance for stereophonic playback errors12V DC trigger input/outputgold-plated binding post speaker terminalsdetachable power cord17-1/8W x 7-7/16H x 17-1/16Dweight: 51.8 lbs.Detailed Description: Onkyo M-5000R Audiophile Stereo Power Amplifier, music, when you hear it in all its glory, has the power to lift the spirits and transport you into another realm. Driving you there in audiophile style is Onkyo’s newest hi-fi power amplifier, the M-5000R. Signal quality on the M-5000R is meticulously preserved by new AWRAT technology, while three-stage inverted Darlington circuitry provides extremely efficient power output. Massive twin toroidal transformers and four 27,000 ?F capacitors work to stabilize the power supply and current, respectively. And to minimize errors in stereophonic playback, the amplifier incorporates a totally symmetrical alignment of power devices for left and right channels. AWRAT (Advanced Wide Range Amplifier Technology)The M-5000R employs a host of proprietary Onkyo technologies to ensure optimal audio performance. 1. DIDRC (Dynamic Intermodulation Distortion Reduction Circuitry)Since the advent of digital audio, signal-to-noise ratios have improved dramatically. However, the S/N ratio reflects static noise only, and takes no account of another type of noise that occurs as the byproduct of sound reproduction—dynamic noise. To reduce this type of noise, Onkyo has developed DIDRC technology for use in our hi-fi components. Despite being beyond the normal range of human hearing, frequencies above 100 kHz are susceptible to clock pulse and other forms of distortion from digital devices. Such distortion in the super high frequency range can generate “beat interference”, which in turn affects the character or atmosphere of the original sound. By improving linearity and reducing distortion in the super-high frequency range, Onkyo’s new DIDRC technology effectively reduces perceptible noise. 2. Low Negative-Feedback DesignToo much NFB makes a system susceptible to counter-electromotive force from the speakers, resulting in a drop in perceived sound quality. To avoid this, Onkyo focuses on improving the frequency response and reducing distortion, without relying so much on NFB. 3. Closed Ground-Loop CircuitsThe M-5000R employs a sophisticated closed-circuit design in which each circuit has a separate link to the power supply. This helps to cancel individual circuit noise and keep the ground potential free of distortion. 4. HICC (High Instantaneous-Current Capability)Handling current loads up to 150 amperes, HICC enables an amplifier to immediately cancel the speakers’ reflex energy and instantaneously send out the next signal. The same high current required to achieve this also supports the amplifier’s ability to handle speaker impedance fluctuations.5. Symmetrical Twin-Monaural ConstructionPower devices for the left and right channels of the M-5000R are aligned symmetrically. Each channel has the same electrical and structural design, and signal pathways are uniform in length. This helps to minimize errors in stereophonic playback. Quad Push-Pull Amplification Design with Three-Stage Inverted Darlington CircuitryThree-stage inverted Darlington circuitry brings greater efficiency to the M-5000R power amp by employing a low-NFB design to maintain voltage stability and enhance transient response. Extremely sensitive to oscillations, this circuitry requires very advanced control technology in order to be incorporated into the amplifier. Breaking further new ground, the M-5000R employs two extra transistors for each channel in a “quad push-pull” design that significantly enhances amplification power. BTL (Bridged Transless) CapabilityThe M-5000R offers the audiophile possibilities of BTL through its pro-grade XLR input. You can use the BTL feature in conjunction with a compatible pre-amp and a second power amp to double the power output for left and right channels. Audiophile-Quality PartsThe M-5000R incorporates two massive toroidal transformers that reduce magnetic flux leakage, improve efficiency, and keep the power supply stable. Also on-board are a sub-transformer and four 27,000 microfarad capacitors that work to make the current significantly smoother. Gold-plated, machined solid brass terminals ensure an extremely clean connection. New Circuit Board ConstructionRather than being directly connected to the chassis base, the circuit boards inside the M-5000R are cushioned by internal struts and affixed to the front, side, and rear panels. This method of construction prevents vibrations from the chassis from adversely affecting the circuit boards. Separate Panel ConstructionThe M-5000R features separate aluminum panels for the top, sides, and front to reduce unwanted vibrations caused by internal resonance. Compared to a one-piece chassis design, this construction method offers greater rigidity and improved noise reduction.
| 
Onkyo A 5000 Verstärker Hersteller: OnkyoModell: A-5000Typ: VollverstärkerBaujahre: 1975 - 1978Hergestellt in: JapanFarbe: SilberNeupreis ca.: 700 DMSpecifications Power output: 33 watts per channel into 8? (stereo) Frequency response: 20Hz to 25kHz Total harmonic distortion: 0.3% Damping factor: 40 Input sensitivity: 8mV (mic), 2.5mV (MM), 200mV (DIN), 200mV (line) Signal to noise ratio: 80dB (MM), 85dB (line) Speaker load impedance: 8? (minimum) Semiconductors: 5 x IC, 8 x transistors, 14 x diodes Dimensions: 414 x 150 x 304mm Weight: 8kg
Onkyo T-5000 AM/FM Tuner. Ungeprft, kann nur soviel sagen die Hintergrund Beleuchtung geht an beim einschalten mehr weis ich nicht, daher wird er als defekt verkauft
Live search